Masterpage:Right-No-Heading
Filename [DR-M1EK_11Subsidiary.fm]
Page 93 August 29, 2003 6:44 pm
93
AUDIO OUTPUT(The boldface settings in the table below indicate the settings at your purchase.)
8DIGITAL AUDIO OUT
DOLBY DIGITAL/PCM
STREAM/PCM
PCM ONLY
Set to the appropriate mode according to the type of the device connected to
DIGITAL AUDIO OUT connector.
DOLBY DIGITAL/PCM:
Select this when you connect the digital input connector of a Dolby
Digital decoder or an amplifier with a built-in Dolby Digital
decoder.
STREAM/PCM:
Select this when you connect the digital input connector of an
amplifier with a built-in DTS, Dolby Digital, or MPEG multichannel
decoder.
PCM ONLY:
Select this when you connect the linear PCM digital input of other
audio equipment (amplifier, MD or DAT deck, etc.).
8ANALOG AUDIO OUT
STEREO
DOLBY SURROUND
Select the appropriate setting to accommodate the unit to the connected A/V
equipment. This function takes effect when a DVDVIDEO disc is played back.
STEREO:
Select this when listening to conventional two-channel stereo audio
with the unit’s AUDIO OUT connectors connected to a stereo
amplifier/receiver or TV set, or in case you want to record the audio
from a DVD VIDEO disc to a Mini Disc, etc.
DOLBY SURROUND:
Select this when listening to multichannel surround audio with the
unit’s AUDIO OUT connectors connected to an amplifier/receiver
with a built-in surround decoder or a surround decoder.
8D. RANGE CONTROL
NORMAL
WIDE RANGE
TV MODE
The dynamic range (the difference between the loudest sound and the quietest
one) can be compressed during playback of a programme encoded in Dolby
Digital format.
This function takes effect when a DVDVIDEO disc recorded in Dolby Digital
format is played back at low or middle volume.
NORMAL:
Normally select this setting to activate this function.
WIDE RANGE:
Select this to deactivate this function when you enjoy wide dynamic
range programme.
TV MODE:
Select this when you hear the sound through the TV’s speaker(s).
NOTES:
●This function takes no effect on programmes other than that recorded in Dolby Digital
format.
●This function dose not work when Simulated Surround Effect is activated. (墌pg.47)
●The effect of “NORMAL” and “WIDE RANGE” may not be different depending on discs.
8OUTPUT LEVEL
STANDARD
LOW
You can lower the output level of analog audio to accommodate the unit to the
connected A/V equipment.
STANDARD:
Normally select this setting.
LOW:
The output level of analog audio is lowered.
DR-M1EK_11Subsidiary.fm Page 93 Friday, August 29, 2003 6:45 PM