JVC LPT0827-001B, DR-M1SLB manual Before performing On-Disc Timer Programming

Models: LPT0827-001B DR-M1SLB

1 116
Download 116 pages 26.63 Kb
Page 60
Image 60

60

TIMER RECORDING (cont.)

On-Disc Timer

Programming

On-Disc Timer Programming is a function used with discs that are especially intended for a specific programme. The disc is then programmed for a programme you always watch every day or every week. Since older programs are automatically overwritten, a single DVD-RAM/RW (VR mode) disc can be used without worrying about how much recording capacity remains. ( pg. 62, “How discs are overwritten”)

You can programme each disc to timer-record as many as

8programmes.

Before performing On-Disc Timer Programming:

Turn on the unit.

Turn on the TV and select the AV mode.

Slide the TV/CABLE/SAT/DVD switch to DVD.

Make sure that the unit’s built-in clock is set properly.

ATTENTION:

On-Disc Timer Programming is possible only with the disc for On-Disc Timer Programming.

If data is recorded on a disc for On-Disc Timer Programming using a unit from another manufacturer, On- Disc Timer Programming may no longer function properly.

To make the disc for On-Disc Timer Programming

A Load a disc.

APress x to open the disc tray.

BPlace a recordable disc on the disc tray.

For details, refer to “Placing a Disc” ( pg. 10).

CPress x to close the disc tray.

B Access Programme Check screen.

Press PROG/CHECK.

C Access the programme screen.

When On-Disc Timer Programming is made for the first time on the disc

Press rt repeatedly to select “DISC TIMER PRGM”, then press ENTER.

When some programmes are recorded on the disc, a caution message appears. In such a case, backup the programmes as

required, then format the disc before making On-Disc Timer Programming. ( pg. 106, “Format a disc”)

When On-Disc Timer Programming has already been made on the disc

Press rt repeatedly to select “NEW TIMER PROGRAMME”, then press ENTER.

D Enter the recording date.

Press rt repeatedly to set the desired date.

The current date appears on the TV screen. The date you enter appears in its place.

E Enter the recording start time.

Press w e to select “START”, then press rt repeatedly to set the desired start time.

Each press of rt advances/goes back the start time in 1-min. increments.

To advance/go back the start time in 30-min. increments, press and hold rt.

Page 60
Image 60
JVC LPT0827-001B, DR-M1SLB manual Before performing On-Disc Timer Programming