JVC LPT1029-001A manual Scan Mode Set, To turn off superimposed indications, Normally select this

SUBSIDIARY SETTINGS EN 73

DISPLAY SET

8SUPERIMPOSE ^ OFF / AUTO

When this function is set to AAUTOB, various operational indicators appear on the TV screen.

OFF:

To turn off superimposed indications.

AUTO:

To superimpose operational indications for approximately five seconds just after the corresponding operation.

NOTES:

●Even when ASUPERIMPOSEB is set to AOFFB, you can display the various operational indicators by pressing ON SCREEN. To clear the operational indicators, press ON SCREEN again.

●When you use this unit as the source player for editing, be sure to set ASUPERIMPOSEB to AOFFB before starting. (A pg. 65)

●When you select AAUTOB, during playback, the operation mode indicators may be disturbed depending on the type of disc being used.

8BLUE BACK ^ OFF / ON

When this function is set to AONB, the TV screen becomes all blue when receiving a channel not in use.

NOTE:

When you want to receive an unstable channel with poor signals, set this function to AOFFB.

8DIMMER ^ BRIGHT / DIMMED

You can change the brightness of the front display panel.

BRIGHT:

Normally select this.

DIMMED:

To dim the front display panel. (Blue lamp on the front display panel is turned off.)

8POWER SAVE ^ OFF / ON

When this function is set to AONB, you can reduce the power consumption while the unit is turned off.

NOTES:

●During Power Save mode ^

^the front display panel will be turned off.

^the Just Clock function (A pg. 78) does not work.

●Power Save does not work when ^

^the unit is in the Timer mode.

^the unit’s power is turned off after timer recording or Instant Timer Recording.

^the Automatic Satellite Programme Recording mode is engaged. (A pg. 51)

^AL-2 SELECTB is set to ADECODERB, ASAT VIDEOB or ASAT S-VIDEOB. (A pg. 67)

●It takes some time for the unit to complete initialisation after you turn on the unit power, with AWAKE UPB blinking on the front display panel.

Scan Mode Set

If you connect the unit and TV with Component Video Connection (A pg. 18), you can select the scan mode from two modes: Interlaced scan mode which is used in the conventional TV system, and Progressive scan mode which enables reproduction of higher-quality images.

8Interlaced scan

In the conventional video system, a picture is shown on the display monitor in two halves. The Interlaced scan system places lines of the second half of the picture in-between lines of the first half of the picture.

8Progressive scan

Progressive scan displays all the horizontal lines of a picture at one time, as a single frame. This system can convert the interlaced video from DVD into progressive format for connection to a progressive display. It dramatically increases the vertical resolution.

ATTENTION:

Your TV needs to be compatible with PAL Progressive.

●Turn on the unit.

●Turn on the TV and select the AV mode.

●Slide the TV/CABLE/SAT/DVD switch to DVD.

CABLE/SAT

TVDVD

PROGRESSIVE SCAN

1Press PROGRESSIVE SCAN for 3 or more seconds.

●Video output indicator (q) lights on the front display panel if Progressive scan mode has been established. (A pg. 13)

●Each press of PROGRESSIVE SCAN for 3 or more seconds switches the scan mode.

NOTES:

●When the progressive mode is set, be sure to set AL-1 OUTPUTB to ACOMPONENTB (A pg. 66). Progressive scan is output only from [COMPONENT VIDEO OUT] connector.

●Interlaced scan mode is the setting at your purchase.

●Interlaced scan mode might be suitable depending on video material.

●Scan mode cannot be set while menu screen is displayed.

●When the Progressive scan mode is engaged, no video signal is output from [L-1 IN/OUT] connector.