GET OVER IT! – CONNECTIONS – EN 15

Connections

It’s essential that your unit be properly connected.

ATTENTION:

Your TV must have a 21-pin AV input connector (SCART) for the connection to the unit.

THESE STEPS MUST BE COMPLETED BEFORE ANY VIDEO OPERATION CAN BE PERFORMED.

Composite Connection

1 Disconnect the TV aerial cable from the TV.

2 Connect the TV aerial cable to the [ANTENNA IN] connector on the rear panel of the unit.

3 Connect the [ANTENNA OUT] connector on the rear panel of the unit and the TV’s aerial connector with the provided RF cable.

1 Make sure the package contains all of the accessories listed in “SPECIFICATIONS” on page 95.

2 Place the unit on a stable, horizontal surface.

3 Connect the unit to a TV depending on the TV and cables you use.

( pg. 15, “Composite Connection”)

( pg. 16, “Component Video Connection (DVD deck only)”)

Aerial connector

Back of TV

RF cable

TV aerial cable

(provided)

 

21-pin SCART connector

21-pin SCART cable (provided)

AC power cord

ANTENNA IN

Back of unit

AC outlet

L-1 IN/OUT

 

ANTENNA OUT

4 Connect the [L-1 IN/OUT] connector on the rear panel of the unit and the TV’s 21-pin SCART connector with a provided 21-pin SCART cable.

The [L-1 IN/OUT] connector accepts and delivers either a composite signal (regular video signal), Y/C signal or RGB signal.

Set your TV to the VIDEO (or AV), Y/C, or RGB mode according to the type of your TV’s SCART connector.

Select an appropriate option of “L-1 OUTPUT” as follows ( pg. 44):

When your TV’s SCART

Set “L-1 OUTPUT” to:

connector accepts:

 

 

 

Composite video signals

“SCART VIDEO”

 

 

Y/C signal (separated

“SCART S-VIDEO”

luminance (brightness) and

 

chrominance (colour)

 

signals)

 

 

 

RGB signal

“SCART RGB”

 

 

5 Plug the end of the AC power cord into an AC outlet.

“LOADING” blinks on the front display panel when the AC plug of the power cord is connected into a AC outlet and no operation will be done for approximately 50 seconds. This is not a malfunction.

After connection is completed, perform “Auto Set Up” on page 17.

Page 15
Image 15
JVC LPT1092-001A manual Connections, Composite Connection, Luminance brightness