
16 EN GET OVER IT! – CONNECTIONS –
Component Video Connection (DVD deck only) |
|
|
| ATTENTION: | |
|
| Your TV also must have a component video input |
|
| connectors for the connection to the unit. |
|
|
|
Back of TV
| Aerial connector |
Component video input connectors | |
Component video cable | RF cable |
(not provided) | (provided) |
1 Perform 1 – 3 in “Composite Connection” ( pg. 15).
2 Connect the unit’s [COMPONENT VIDEO OUT] connectors to the TV’s component video input connectors.
3 Connect the unit’s [AUDIO OUT] connectors to the TV’s AUDIO input connectors.
● You can obtain
OUT] connectors to connect to an audio amplifier for
● By using the component video connection, you can view the images in the progressive mode. For switching to the progressive mode, refer to “Scan Mode Set” ( pg. 80).
4 Plug the end of the AC power cord into an AC outlet. ● “LOADING” blinks on the front display panel when the AC plug of the power cord is connected into an AC outlet and
TV aerial cable | no operation will be done for approximately 50 seconds. |
| |
| This is not a malfunction. |
|
|
| After connection is completed, perform “Auto Set Up” on |
| page 17. |
|
|
AC power cord
Back of unit
ANTENNA IN
AC outlet
COMPONENT VIDEO OUT
ANTENNA OUT