SYSTEM CONNECTIONS EN 77

Connecting To A Dolby Digital Decoder

When you can’t switch the audio channel of a bilingual

programme

Or An Amplifier With Built-in DTS

When the unit is connected with a digital audio device using an

optional coaxial cable and “DIGITAL AUDIO OUT” is set to

 

“DOLBY DIGITAL/PCM”, it is not possible to switch the audio

These instructions enable you to connect your unit to a Dolby

channel of a bilingual programme recorded on a DVD-RAM or

Digital Decoder or an amplifier with built-in DTS.

DVD-RW (VR mode) disc. In this case, perform the following steps

 

using the remote control to switch “DIGITAL AUDIO OUT” from

 

“DOLBY DIGITAL/PCM” to “PCM ONLY”.

 

A Press SET UP to access the Main Menu screen.

 

B Press w e to select “DVD SET UP”, then press t.

 

C Press w e to select “AUDIO OUTPUT”, then press t.

 

D Press rt to select “DIGITAL AUDIO OUT”, then press

 

ENTER.

 

E Press rt to select “PCM ONLY”, then press ENTER.

 

( pg. 78)

 

F Press SET UP to complete the setting.

 

G Press AUDIO to select the desired audio channel. ( pg. 50)

Dolby Digital Decoder or amplifier with built-in DTS

To DIGITAL AUDIO input

Coaxial cable (not provided)

To [DIGITAL AUDIO

OUT (COAXIAL)]

Connecting/Using A Decoder (DVD Deck Only)

The [L-2 IN/DECODER] connector can be used as an input connector for an external decoder (descrambler). Simply connect a decoder and you can enjoy a variety of programming that is available through scrambled channels.

Decoder

Rear of unit

1 Connect the unit and a Dolby Digital Decoder or an amplifier with built-in DTS using an optional coaxial cable.

NOTES:

For Dolby Digital sound, set “DIGITAL AUDIO OUT” to “DOLBY DIGITAL/PCM”. ( pg. 78)

For DTS sound, set “DIGITAL AUDIO OUT” to “STREAM/PCM”. ( pg. 78)

CAUTIONS:

This unit has a dynamic range of more than 110 dB with regards to its Hi-Fi audio capability. It is recommended that you check the maximum level if you are going to listen to the Hi-Fi audio signals through a stereo amplifier. A sudden surge in the input level to the speakers may damage them.

Some speakers and televisions are specially shielded to prevent television interference. If both are of the non-shielded type, do not place the speakers adjacent to the TV set as this can adversely affect the playback picture.

 

TV aerial cable

TV

L-1 IN/OUT

 

L-2 IN/

 

DECODER

 

RF cable (provided)

1Set “L-2 SELECT” to “DECODER”. ( pg. 45)

2Connect your unit’s [L-2 IN/DECODER] connector to the decoder’s 21-pin SCART connector using a 21-pin SCART cable.

3Perform the procedure as described in “When Receiving A Scrambled Broadcast (DVD Deck Only)” ( pg. 87). (DVD deck only)

Page 77
Image 77
JVC LPT1092-001A manual Connecting/Using a Decoder DVD Deck Only, When you can’t switch the audio channel of a bilingual