JVC LYT0844-001A specifications 50 EN, Fade/Wipe Effects, FADE/WIPE Selection

To Deactivate The Selected Effect . . .

... select “OFF” in step 4.

PICTURE WIPE OR DISSOLVE SELECTION

( , , , , , and ) The Picture Wipe or Dissolve works when video recording is started.

1 Follow steps 1 through 4 above.

2 Engage the Record-Standby mode.

If you select Picture Wipe/Dissolve during recording . . .

.... press the Recording Start/Stop Button when one

scene is finished. The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode . . .

.... press the Recording Start/Stop Button to start

recording and press it again when one scene is finished. The point at which the scene ended is stored in memory.

If you select Picture Wipe/Dissolve during Record- Standby mode after performing a Picture Wipe/ Dissolve . . .

.... the point at which the scene ended is already

stored in memory.

3 If you start recording a new scene within 5 minutes of the end of the previous recording (without having turned the camcorder’s power off), the previous scene wipes out, revealing the new scene.

50 EN

Fade/Wipe Effects

These effects let you make pro-style scene transitions. Use them to spice up the transition from one scene to the next. You can also vary transitions from scene to scene.

IMPORTANT:

Some Fade/Wipe Effects cannot be used with certain modes of Program AE with special effects (
pg. 48, 49). If an unusable Fade/ Wipe Effect is selected, its indicator blinks or goes out.

VIDEO/MEMORY

Switch

Recording Start/

Stop Button

Power Switch

Lock Button

MENU Button

SET/SELECT Button +, – Button

NOTES:

●You can extend the length of a Fade or Wipe by pressing and holding the Recording Start/ Stop Button.

●If the power is turned off after a scene is finished recording, the stored point is erased, disabling the Picture Wipe/Dissolve combination. When this happens, the Picture Wipe/Dissolve indicator blinks. Also note that power shuts off automatically if 5 minutes elapse in the Record-Standby mode.

●The sound at the end of the last recorded scene is not stored.

FOR RECORDING (cont.)

FADE/WIPE SELECTION (					,	,	,	,
,	,	,	,	and	)

Fade or Wipe works when video recording is started or when you stop recording.

1 Set the VIDEO/MEMORY Switch to “VIDEO”, then set the Power Switch to “ ” while pressing down the Lock Button located on the switch. Open the LCD monitor fully or pull out the viewfinder fully.

2 Press MENU. The Menu Screen appears.

Press + or – to select “	WIPE/FADER”, then press
3 SET/SELECT.

4 Press + or – to select the desired function, then press SET/SELECT. Selection is complete. Press SET/ SELECT again.

•The WIPE/FADER Menu disappears and the effect is reserved. The indicator representing the selected effect appears.

5 Press the Recording Start/Stop Button to activate the Fade-in/out or Wipe-in/out.