DETAILS | EN77 | |
I T E M S | N O T E S |
|
|
|
|
➪ Power | ❍ Perform charging where the temperature is between 10°C and | |
( pg. 10) | 35°C. 20°C to 25°C is the ideal temperature range for charging. If | |
| the environment is too cold, charging may be incomplete. | |
❍Charging times noted above are for a fully discharged battery pack.
❍Charging time varies according to the ambient temperature and the status of the battery pack.
❍To avoid interference with reception, do not use the AC Power Adapter/Charger near a radio.
❍Since the AC Power Adapter/Charger processes electricity internally, it becomes warm during use. Be sure to use it only in
➪ VIDEO | ❍ When you use the LCD monitor outdoors in direct sunlight, the | |||||||||||||||||||
RECORDING | LCD monitor may be difficult to see. If this happens, use the | |||||||||||||||||||
( pg. 20, 21) | viewfinder instead. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
| ❍ The cassette holder cannot be opened unless a power supply is | |||||||||||||||||||
| attached. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
| ❍ There may be a delay after you open the cassette holder cover | |||||||||||||||||||
| until the cassette holder opens. Do not use force. | |||||||||||||||||||
| ❍ Once the cassette holder is closed, it recedes automatically. Wait | |||||||||||||||||||
| until it recedes completely before closing the cassette holder | |||||||||||||||||||
| cover. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
| ❍ When the Recording Start/Stop button is pressed, it may take a | |||||||||||||||||||
| few seconds before actual recording starts. “ ” starts rotating | |||||||||||||||||||
| when the camcorder actually starts recording. | |||||||||||||||||||
| ❍ The time required to calculate and display the remaining tape | |||||||||||||||||||
| length, and the accuracy of the calculation, may vary according | |||||||||||||||||||
| to the type of tape used. |
|
|
|
|
|
|
|
|
|
|
|
| |||||||
| ❍ “TAPE END” appears when the tape reaches its end, and the | |||||||||||||||||||
| power goes off automatically if left in this condition for | |||||||||||||||||||
| 5 minutes. “TAPE END” also appears when a cassette at its end is | |||||||||||||||||||
| loaded. |
|
|
|
|
|
|
|
|
|
|
|
|
| ||||||
| ❍ During recording, sound is not heard from the speaker. To hear | |||||||||||||||||||
| the sound, connect optional headphones to the PHONE | |||||||||||||||||||
| connector on the Docking Station. The sound volume is at the | |||||||||||||||||||
| level it was adjusted to during playback ( pg. 23). | |||||||||||||||||||
| ❍ During Interface Shooting, the “Tape Running” indicator and | |||||||||||||||||||
| warning indications ( pg. 91, 92) are the only ones that are | |||||||||||||||||||
| shown; they appear reversed in the display as they would when | |||||||||||||||||||
| viewing a mirror, but are not reversed in the recording. | |||||||||||||||||||
| ❍ The tape remaining indicator does not appear during interface | |||||||||||||||||||
| shooting. However, when the remaining time reaches 2 minutes, | |||||||||||||||||||
| the indicator appears showing the remaining time: |
|
|
|
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
| ||||||||||||
|
|
|
|
|
|
|
|
| ||||||||||||
| (blinking) |
|
|
|
|
|
| (blinking) |
|
|
| (blinking) | ||||||||
|
|
|
|
|
|
|
|
|
| |||||||||||
|
|
|
|
|
|
|
|
|
| |||||||||||
