JVC MA372IEN user service KD-S15

KD-S15

CD RECEIVER: INSTRUCTIONS/INSTALLATION

GET0561-001A

[J]

ENGLISHESPAÑOL

INFORMATION (For U.S.A.)

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

–Reorient or relocate the receiving antenna.

–Increase the separation between the equipment and receiver.

–Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

–Consult the dealer or an experienced radio/TV technician for help.

Thank you for purchasing a JVC product.

Please read all instructions carefully before operation, to ensure your complete understanding and to obtain the best possible performance from the unit.

Installation/connection are explained at the last section of this manual (reverse page, indicated with symbol).

For customer Use:

Enter below the Model No. and Serial No. which are located on the top or bottom of the cabinet. Retain this information for future reference.

Model No.	0508DTSMDTJEIN
Serial No.	EN
	© 2008 Victor Company of Japan, Limited

MAINTENANCE

How to clean the connectors	To keep discs clean
Wipe the connectors with	Wipe in a straight line from center of disc to
a cotton swab or cloth	edge. Do not use liquid cleaners, thinners, or
moistened with alcohol.	benzene.
	Connectors

Moisture condensation	To play new discs
Moisture may condense on the lens inside the unit. Eject	Remove any rough areas from the inner and
the disc and leave the unit turned on for a few hours until	outer edges of the disc.
the moisture has evaporated.

Caution

Changes or modifications not approved by JVC could void the user’s authority to operate the equipment.

IMPORTANT FOR LASER PRODUCTS

1.CLASS 1 LASER PRODUCT

2.CAUTION: Do not open the top cover. There are no user serviceable parts inside the unit; leave all servicing to qualified service personnel.

3.	CAUTION: (For U.S.A.)	Visible and/or invisible class II laser radiation when open. Do not stare into beam.
	(For Canada)	Visible and/or invisible class 1M laser radiation when open. Do not view directly with optical
		instruments.
4.	REPRODUCTION OF LABEL: CAUTION LABEL, PLACED OUTSIDE THE UNIT.

[European Union only]

For safety...		Warning
•	Do not raise the volume level too much, as this will block	If you need to operate the unit while driving, be sure to
	outside sounds, making driving dangerous.	look around carefully or you may be involved in a traffic
•	Stop the car before performing any complicated	accident.
	operations.

Temperature inside the car...	Caution on volume setting
If you have parked the car for a long time in hot or cold	Discs produce very little noise compared with other sources.
weather, wait until the temperature in the car becomes	Lower the volume before playing a disc to avoid damaging
normal before operating the unit.	the speakers by the sudden increase of the output level.

MORE ABOUT THIS UNIT

Do not use the following discs:

Single CD—8 cm (3-3/16”) disc Warped disc Sticker and sticker residue Stick-on label

		Transparent or semi-transparent
Unusual shape	C-thru Disc (semi-transparent disc)	parts on its recording area

PREPARATIONS

How to reset your unit Detaching the control panel

Reset the unit after installation is complete.

• Your preset adjustments will also be erased. Attaching the control panel

How to forcibly eject a disc

• Be careful not to drop the disc when it ejects.

Basic operations

•By pressing SRC on the unit, you can also turn on the power. If the source is ready, playback also starts.

•If you turn off the power while listening to a disc, disc play will start from where it had been stopped previously next time you turn on the power.

•When no disc is loaded in the unit, you cannot select “CD” as the playback source.

Tuner operations

•During SSM search...

–All previously stored stations are erased and the stations are stored anew.

–Received stations are preset in No. 1 (lowest frequency) to No. 6 (highest frequency).

–When SSM is over, the station stored in No. 1 will be automatically tuned in.

Disc operations

Caution for DualDisc playback

•The Non-DVD side of a “DualDisc” does not comply with the “Compact Disc Digital Audio” standard. Therefore, the use of Non-DVD side of a DualDisc on this product may not be recommended.

General

•This unit has been designed to reproduce CDs/CD Texts, and CD-Rs (Recordable)/CD-RWs (Rewritable) in audio CD (CD-DA).

•After ejecting a disc, “NO DISC” appears and you cannot operate some of the buttons. Insert another disc or press SRC to select another playback source.

Playing a CD-R or CD-RW

•Use only “finalized” CD-Rs or CD-RWs.

•This unit can play back multi-session discs; however, unclosed sessions will be skipped while playing.

•Some CD-Rs or CD-RWs may not be played back on this unit:

–Discs are dirty or scratched.

–Moisture condensation has occurred on the lens inside the unit.

–The pickup lens inside the unit is dirty.

–The files on the CD-R/CD-RW are written using the “Packet Write” method.

–There are improper recording conditions (missing data, etc.) or media conditions (stained, scratched, warped, etc.).

•CD-RWs may require a longer readout time since the reflectance of CD-RWs is lower than that of regular CDs.

• If this does not work, reset your unit.

Basic settings

Enter PSM menu.	Cancel the display	Set the clock
	demonstration

Select an item.

Adjust.

Deactivate the display	Adjust the hour.	Adjust the minute.
demonstration.

Finish

1– EN