JVC NX-HD10 11

– 11 –

English

Setting the Clock

You can set the clock whether the unit is turned on or in

standby mode.

On the remote control ONLY:

Press CLOCK/TIMER.

The day of the week starts flashing in the main display.

Press SELECT ¢ or SELECT 4 to select the

correct day of the week, then press SET.

• When you press and hold SELECT ¢ or

SELECT 4, the day of the week changes

continuously.

Press SELECT ¢ or SELECT 4 to adjust the hour,

then press SET.

• When you press and hold SELECT ¢ or

SELECT 4, the hour digit changes continuously.

• If you want to correct the hour after pressing SET,

press CANCEL. The hour digit starts flashing again.

Press SELECT ¢ or SELECT 4 to adjust the

minute, then press SET.

• When you press and hold SELECT ¢ or

SELECT 4, the minute digit changes continuously.

“ADJUST OK” appears in the main display, and the

built-in clock starts.

Before operating the unit any further, first set the clock

built in this unit, then some other basic settings.

Turning On the Power

When you press one of the source selecting buttons—

HDD 3/8, CD 3/8, TUNER/LINE, the unit automatically

turns on (and starts playback if the source is ready).

To turn on the unit without playing, press

STANDBY/ON so that the STANDBY/ON lamp on

the unit lights in green.

• The HDD lamp flashes then lights in blue. The

VOLUME lamp also lights in blue. While the HDD lamp

is flashing, no remote control operations are accepted.

For detailed information on the HDD lamp, see page 30.

(See also “Changing the Display Brightness” on the next

page.)

• The indicator starts flashing if the built-in clock is

not set. (It lights if the clock is already set.)

To turn off the unit (on standby), press

STANDBY/ON again so that the STANDBY/ON lamp

lights in red.

If Smart Compression has been turned “ON” (see page

40), it starts working and the STANDBY/ON lamp

flashes in green while Smart Compression is

performed. Then the unit will turn off (on standby).

A little power is always consumed even while the unit is in

standby mode.

To switch off the power supply completely, unplug the

AC power cord from the AC outlet.

DO NOT unplug the AC power cord in the following

cases; otherwise, the data in the HDD may be

damaged:

• While recording or editing.

• While Smart Compression is working.

When you unplug the AC power cord or if a power

failure occurs

The clock is reset to “Monday AM12:00” after about a minute,

while the tuner preset stations and other settings will be erased in a

few days.

The hour digit in the main display starts flashing.

The minute digits start flashing.

EN10-16_NX-HD10[J_C]f.pm6 02.6.14, 10:20 PM11