JVC RX-554RBK manual Operating Other Components

Operating Other Components

You can operate JVC audio and video components with this receiver’s remote control.

To operate these components with the remote control, first select a source with the source buttons on the remote control. Then, operate that source using the remote control.

English

IMPORTANT:

To operate JVC audio components using this remote control:

•You need to connect JVC audio components through the COMPU LINK-3 (SYNCHRO) jacks (see page 37) in addition to the connections using cables with RCA pin plugs (see page 7).

•Aim the remote control directly at the remote sensor on the receiver.

Note:

If you choose a source on the front panel, the remote control will not operate that source.

7After pressing TUNER/BAND, you can perform the following operations:

TUNER/BAND	Alternates between FM and AM (MW/LW).
1 – 10, +10	Selects a preset channel number directly.
	For channel number 5, press 5.
	For channel numver 15, press +10, then 5.
	For channel number 20, press +10, then 10.
	For channel number 30, press +10, +10
	then 10.
RDS operating buttons
PTY SEARCH	Starts and ends searching a broadcast
	using the RDS.
PTY SELECT +/–Selects a program type.
DISPLAY	Changes the RDS display mode.

CD TV VCR AUDIO

TAPE	DAP MODE	3D-PHONIC	SURROUND
	1	2	3
TUNER/	EFFECT	DELAY	TEST
BAND	4	5	6
VCR	SEA MODE	– REAR +
	7/P	8	9
VIDEO	SEA	– CENTER +
	PRESET	10	+10
PHONO	SOUND		ONE TOUCH
	CONTROL CD-DISC OPERATION
– TV CH +		– VCR CH +
– TV VOL. +		PTY SEARCH	DISPLAY

TV/

VIDEO

–PTY SELECT +

– VOLUME + MUTING

RM-SR554RU REMOTE CONTROL

7After pressing CD, you can perform the following

operations on the CD player:

3 Starts playing.

4Returns to the beginning of the current (or previous) track.

¢Skips to the beginning of the next track.

7	Stops playing.
8	Pauses. To resume playing, press 3.
1 – 10, +10	Selects a track number directly.

For track number 5, press 5.

For track number 15, press +10, then 5. For track number 20, press +10, then 10.

For track number 30, press +10, +10, then 10.

7After pressing CD-DISC, you can perform the following operations on the CD changer:

1 – 6, 7/P Select the number of a disc installed in a CD changer. Then continue to operate the CD player as described above.

For example: To find a track number 11 of disc 4

1.Press CD DISC.

2.Press 4.

3.Press CD.

4.Press +10, then 1.

7After pressing TAPE, you can perform the following operations on the cassette deck:

3 Starts playback.

4Fast winds a tape from right to left.

¢Fast winds a tape from left to right.

7	Stops operation.
8	Pauses. To resume playing, press 3.

Note:

If you press SOUND CONTROL, you cannot operate the cassette deck with this remote control. If this happens, press TAPE again, so operating buttons for audio components will work for the cassette deck.

38