JVC SR-DVM700E manual Arecb, Audio Output

		EDITING EN 53
	Audio Dubbing (DV Deck Only)
		● Slide the TV/DVD switch to DVD.
		1 Connect an audio device to the unit’s [AUDIO] input connectors
This function allows you to record new audio, without erasing the
original audio, on a DV tape that was recorded with ADV AUDIO		on the front panel.
		● When using a monaural audio device, connect its AUDIO OUT
RECB set to A12BITB (A pg. 59).
		connector to the [AUDIO-L] input connector on your unit.

ATTENTION:

You cannot perform Audio Dubbing on a tape that was recorded with ADV AUDIO RECB set to A16BITB (A pg. 59), on a tape that was recorded at the ALPB speed, or on a blank tape.

Your unit Recorder

INPUT SELECT AUDIO DUB.

To [AUDIO] input

2	Load a Mini DV cassette with the erase protection switch set to
3	ARECB.
	Press DV/HDD/DVD on the unit repeatedly or DV on the remote
4	so that the DV lamp lights up on the unit.
	Press INPUT SELECT +/– on the remote control or
5	INPUT SELECT on the unit to select AF-1B.
	Start playback slightly before the actual point from where you
6	wish to start dubbing.
	Press W to pause playback.
7	Press AUDIO DUB. to engage the audio dubbing mode.
● Your unit enters the Audio Dubbing Pause mode.
● To perform Audio Dubbing with audio mixing, press AUDIO to
	select AL W X RB at this point. When using the DV deck as the
	recording deck, also make sure that AAUDIO MODEB is set to
	ASOUND1B (A pg. 59).

Audio cable (not supplied)

AUDIO OUT

CD player, etc.

CD player, etc.

Mixer output

Original sound

Your unit [AUDIO OUTPUT]

Audio mixer

Recorder

	* Audio Dubbing with audio mixing is not possible if you are using a
8	monaural audio component, or if you don’t have an audio mixer.
	Engage the audio device’s playback, then press I to start the
	tape in the unit. Audio dubbing starts at this point.
● To stop dubbing temporarily, press W. Press I to resume
9	dubbing.
	Press o on the unit, then stop playback on the audio device to
	end the audio dubbing.

NOTES:

●Once the Audio Dubbing starts, you cannot use the other deck.

●When monitoring the audio dubbed sound on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 59).

●When playing back an audio dubbed Mini DV tape on the DV deck, set AAUDIO MODEB to ASOUND2B (A pg. 59).

●Audio dubbing is not possible using the [DV IN/OUT] connector.

●Audio dubbing is not possible on a blank portion of the tape.

To	INPUT SELECT	AUDIO DUB.
[AUDIO]
input