JVC SR-DVM700E manual Other Problems, Recording HDD Deck, Recording DV Deck, For basic connection

TROUBLESHOOTING EN 65

● The DVD-RAM disc loaded has had its protect tab slid to the	Other Problems
protect position.
] Release the protect tab. (A pg. 8)
	The image of the programme appears distorted on the TV
Recording (HDD Deck)	screen.
	For basic connection
Camcorder recording is not possible.	] Press PROGRESSIVE SCAN for 3 or more seconds so that the
	Video output indicator (q) lights off on the front display panel.
● The camcorder has not been properly connected.
	For component video connection
] Confirm that the camcorder is properly connected.
● The input mode is not correct.	] Press PROGRESSIVE SCAN for 3 or more seconds so that the
] Set the input mode to AF-1B. (A pg. 50)	Video output indicator (q) lights up on the front display panel.
Recording (DV Deck)
	Whistling or howling is heard from the TV during camcorder
	recording.
During recording, the tape does not run. The DV recording	● The camcorder’s microphone is too close to the TV.
lamp lights up on the unit.
	] Position the camcorder so its microphone is away from the TV.
● The unit is in the Record Pause mode.	● The TV’s volume is too high.
] Press I to resume recording.	] Turn the TV’s volume down.
Recording cannot be done.
	The AV input cannot be changed.
● There is no cassette loaded, or the cassette loaded has had its
	● Recording or RetroActive Recording* is in progress.
erase protection switch set to ASAVEB.
	] Press W to pause recording, change the AV input, then press I
] Insert a Mini DV cassette, or set the erase protection switch set
	to resume recording.
to ARECB.
	* HDD deck only .

Camcorder recording is not possible.

●The camcorder has not been properly connected. ] Confirm that the camcorder is properly connected.

●The input mode is not correct.

] Set the input mode to AF-1Bor ADVB.

The tape is automatically rewound, then the unit is shut off.

●The end of the tape was reached during recording.

] The programme may not have been recorded in its entirety. Next time make sure you have enough time on the tape to record the entire programme.

Audio dubbing is not possible.

Malfunction occurs and the unit cannot be power off.

] Reset the unit by disconnecting the AC power plug from the AC outlet and connect again.

Buttons and controls do not function at all.

●Mode Lock is activated.

] Press and hold F1 for more than 5 seconds to cancel Mode Lock. Or disconnect the power cord and connect again.

●ADV AUDIO RECB had been set to A16BITB at the original recording.

] Set ADV AUDIO RECB to A12BITB at the original recording.

●The tape speed had been set to LP at the original recording. ] Set the tape speed to SP at the original recording.

Monitoring the audio dubbed sound is not possible during audio dubbing.

] This is normal. Monitor the sound using the connected devices.