Duplex, Four wires must be connected, Simplex

Use twisted-pair cables for the connections.

●Duplex

When the camera is controlled using the full duplex trans- mission protocol, set Switch 5 to OFF.

Camera	Controller
RX+	TX+
RX–	TX–
TX+	RX+
TX–	RX–

Four wires must be connected.

For example (connection with an RM-P2580)

Camera	RM-P2580
RX+ C	C TX+
RX– D	D TX–
TX+ A	A RX+
TX– B	B RX–

●Simplex

When the camera is controlled using the simplex trans- mission protocol, set Switch 5 to ON.

Camera	Controller
RX+	TX+
RX–	TX–

Two wires must be connected.

Page 11

Image 11

JVC TK-C655 manual Duplex, Four wires must be connected, For example connection with an RM-P2580, Simplex

Contents

TK-C655 Important Safeguards Contents Safety Precautions FeaturesProvided Accessories Zooming Precautions for Correct Operation Preset positions Camera setups with which auto focusing may be difficult Ceiling Mount Controls, Connectors and Indicators Ceiling Mount Camera Cable connections P Switch settings PMulti-Drop Communication System Memo Point-to-Point Communication System Turn all the components power off before proceedingConnector side of the Ceiling Mount Switch 7 OFF Switch 8 on For example connection with an RM-P2580 Four wires must be connectedTwo wires must be connected Duplex Setting switches Switch Settings Example Camera ID check procedureMachine ID Bers on the RM-P2580 Pass the cables through the cover Cable ConnectionsMake a 90 mm diameter hole in the ceiling Remove the cover from the Ceiling Mount Coaxial cable Control signal cablesAttach the cover Attaching the Camera Attaching a safety wireAttach the drop prevention wire Attaching the Ceiling Mount Rotate the camera Tighten the lock screw using a Phillips screwdriverEnsure that the locking screw is loose Fit the camera Press the SET button Setup ProcedureSetting the camera menus from an RM-P2580 Press and hold the Menu button for 3 seconds Normal screen Menu Screen Flow Camera Function Screen Camera TITLE/ALARM Screen Camera ALC/ExDR screen Camera Video Adjustment Screen Sense UP AGC Mode Position Function SET Screen Auto PAN/PATROL/TRACE Screen Factory Settings screen Private Mask Setup Repeat steps 5 and 6 for each title character Camera Title SetupPress the Tele button Repeat steps 5 to 7 for each area title Area Title SetupMove the cursor to Area Title Edit and press the SET button Press the FAR button Repeat steps 5 to 7 for each alarm title Alarm Title SetupDisplay the Setup menu on the camera Adjust the viewing angle of the start position Auto PAN SetupSet the auto pan mode and speed Auto Patrol Setup Auto Trace SET screen is displayed Auto Trace SetupMove the cursor to Autotrace SET and press the SET button Set the patrol start position Position Title screen Position Title SetupRepeat steps 5 to 7 for each title character Position Function SET screen Ceiling plate Attaching a Flush Mounted Ceiling Bracket Optional WB-S575Clamp the Flush Mounted Ceiling Bracket Ing Connection Cables Attach the ceiling panel Check the release labels thoroughly before removal Removing a Flush Mounted Ceiling Bracket Optional WB-S575Remove the ceiling panel Remove the camera Symptom Cause Information Remedy Troubleshooting General SpecificationsCamera Pan/Tilt Mechanism WB-S575 Flush Mounted Ceiling Bracket + Ceiling panel External dimensions Unit mmDimensions in combination with the WB-S575 Ceiling Mount hole TK-C655 Dome Type Camera