Setup ProceduresStep 1 Connection/Installation (A Page 17)

Connect the lens mount, power supply cord, LAN cable and alarm.

Next, mount the camera to the ceiling. Remember also to mount the fall prevention wire. After the camera is mounted, connect the video monitor to the [MONITOR OUT] terminal at the rear of the unit, followed by adjusting the camera angle.

You can select the video signals of the [MONITOR OUT] terminal using the

[MONITOR OUT] switch. (ANTSCB or APALB) (Back focus adjustment A Page 23) ([MONITOR OUT] switch A Page 11)

TAfter adjusting the camera angle using the [MONITOR OUT] terminal, set the

[MONITOR OUT] switch to AOFFB. Images are not distributed to the network when ANTSCB or APALB is selected. After changing the [MONITOR OUT] switch setting, press the Reset button to reboot the camera.

G

Step 2 Network settings (A Page 27)

Configure the network settings of the computer and this camera.

TIn a system where multiple units of VN-V25U/ 26U are used, turn on the power of only one unit to configure the IP address settings using the Internet Explorer. Upon doing so, turn on the power of the second unit and configure accordingly. Configure the settings for the other cameras using the same procedure.

G

Step 3 Configuring settings using the Internet Explorer (A Page 33)

Configure the picture quality and alarm settings using the Internet Explorer.

G

Step 4 Operating the built-in viewer (A Page 79)

The built-in viewers enable you to monitor JPEG and MPEG4 images and save JPEG images.

15