When DIGITAL IN UNLOCK is scrolled and displayed, the OPTICAL IN connector is not connected to the source unit.
In the case of an MD with some remaining space, the end of the last track recorded is automatically searched, and recording is commenced immediately.
To record over all the existing tracks, erase all the tracks using the ALL ERASE function (see page 40), and then proceed with the new recordings.
Upon completion of the MD recording, “UTOC WRITING” is displayed. Operating any button while this message is displayed may render the MD unusable.
Always wait for “UTOC WRITING” to be cleared before proceeding with the next operation.
When digital input signals are supplied, they will be recorded in their original digital form. There is no need to adjust their recording level.
CD Recording (single-action recording)
CD play and MD recording are started simultaneously.
English
|
| 3 |
|
|
| ||
CD 3 |
|
|
|
CD 2 |
|
|
|
CD 1 |
|
| |
|
| PLAY & EXCHANGE | |
STANDBY | TIMER | CD PITCH CONTROL |
|
| /CLOCK | 1st TRACK | LISTENING |
|
| REC | EDIT |
POWER |
| NORMAL SPEED |
|
CD REC | SKIP |
1
|
| 32kHz |
REC | REC | REC |
PAUSE | START | STOP |
2 |
|
| 1 |
|
|
|
|
DIGITAL INPUT |
|
|
| DISPLAY |
|
| |
44.1kHz | 48kHz |
| EDIT | TITLE | /CHARA | PLAY MODE | |
|
| MIXING | CANCEL |
|
|
| SET |
DIGITAL | CD | LINE | MIC |
|
|
|
|
| REC SOURCE SELECTOR |
|
|
|
|
| |
|
|
|
| MIX BALANCE | REC LEVEL | ||
|
|
| CD |
|
|
|
|
|
|
| MD | LINE | CD | MIN | MAX |
|
|
|
| MIC | LINE |
|
|
|
|
|
| MIC |
| PHONES | |
SAMPLING RATE CONVERTER
1Select and stop the CD to be recorded.
Example: When recording CD1
• Only the selected CD is recorded.
2Insert the recording MD.
• Insert the MD with its label side facing up.
| CD REC | 3 | Press the CD REC button to start the recording. |
| |||
|
|
|
|
•CD play and MD recording start simultaneously. This is called synchro recording. Recording
starts from track 1.
Remaining play time of | Remaining recording |
track being recorded | time on MD |
CD
MD
TOC REC
DIGITAL
L
R 
40 30 20 15 10 6 3 0 
“DIGITAL” is displayed.
•When a CD is recorded, its digital signals are recorded in their original form. A track mark is automatically placed where one track changes to the next, and the track number also changes.
•When MD recording is completed
After “UTOC WRITING” is displayed, operation stops automatically. It also stops automatically when CD play finishes. CD play is transferred to the next tray.
•
Main unit |
| Remote control |
|
|
|
DISPLAY
/CHARA
The mode changes each time this is pressed.
To check a track number during recording
Press DISPLAY/CHARA button (or DISPLAY MODE on the remote control).
Remaining time of | ä Remaining recording time on MD |
\ |
track being recorded
Ç
CD number and track number ä MD track number
29
