Kathrein cap910 manual Important Instructions for Installation

INSTALLATION AND CONNECTION

Using the adhesive strips supplied, now install the infra-red sensor either on the receiver or at the chosen location. If the infra-red sensor is installed on the unit, its cable can be threaded in at its base, as for a phone, and routed to the rear of the receiver (see diagram on the right).

When threading in the cable, take care not to damage its sheath.

IMPORTANT INSTRUCTIONS FOR INSTALLATION

Under no circumstances use countersunk-head screws for installation (see diagram on the right), since these can damage the screw sockets on the receiver. Wherever possible, use the wood screws supplied with the receiver.

Before installing the receiver so that it is attached to another piece of equipment (such as a TV set), check with the manufacturer of that equipment or by reference to the documentation supplied with it whether this is permissible, and if so what fittings (screws etc.) you need/can use for this. The temperature rise of each of the units in operation (receiver/TV set) can in some circumstances affect the other unit.

The wood screws supplied with the receiver should not under any circumstances be used to attach it to a TV set or other electrical equipment! This could damage that equipment, possibly beyond repair.

Risk of fatal injury due to electric shock!

Use of other screws:

If because of the installation location or factors associated with it, the screws supplied cannot be used, refer to the diagram alongside when selecting the screws to be used. This shows you the cross-section area of the screw sockets on the receiver and shows which screws (diameter, screw head profiles etc.) can be inserted into the receiver support.

6.6

20