MANUAL LOWERING TO PARK POSITION
MANUAL LOWERING
1. In the centre of the axis (arrowed) there are two plastic caps, one to the left and one to the right. Lever this off with a narrow
2. Behind this, each jointed socket carries a central M10 cap screw (8 mm across flats); and one of the two sockets carries an additional 2 M6 cap screws (5 mm across flats). Unscrew each of these four screws.
3. Caution! Secure and support the antenna to prevent it tipping over. The connection to the rocker can suddenly come loose during the next step (item 4). It is then no longer connected to the turntable!
4. Screw an M12 screw into each thread (minimum length: 60 mm). Screwing in the M12 screw pushes the rocker off the taper seating on the tapered shaft and releases the engagement.
Important: Screw the screw in only as far as necessary to free the rocker from engagement on the tapered shaft!
5.Tilt the antenna into the park position (horizontal position).
6.Remove the M12 screw.
7.Screw the M10 screws on each side back in again, and also the two M6 screws on the one side, and tighten them.
8.Replace the plastic caps.
Loosening the rocker from the taper shaft causes the rocker zero point position to be lost. The defect must be eliminated and the rocker recalibrated by an authorised dealer!
9.Consult an authorised dealer.
29
