Mobiset 4 CAP 910 Components / Scope of Delivery | Kathrein cap910

MOBISET 4 CAP 910 COMPONENTS / SCOPE OF DELIVERY

75 cm satellite dish

Twin LNB

Turntable with integral controls and GPS receiver

UFS 940sw (Front view)

See the UFS 940sw operating manual for a rear view of the receiver together with explanation of functions and operating instructions.

PRODUCT PACKAGE

The MobiSet 4 digital CAP 910 consists of:

•Turntable complete with control electronics (and GPS receiver), pre-assembled satellite dish and twin LNB

•Mounting plate

•Complete cabling set: 2 x coax cables each 8 m long, and one power supply cable (10 m) for connection to the on-board power supply

•Roof gland with sealing gasket

•Sikaﬂex® 291 adhesive sealant (100 ml tube)

•UFS 940sw HDTV-DVB-S receiver with connecting cables, infrared sensor and infrared remote control

•MobiSet 4 digital CAP 910 installation manual

•UFS 940sw satellite receiver operating manual

3

Image 3

Kathrein cap910 manual Mobiset 4 CAP 910 Components / Scope of Delivery, Product Package

Contents

CAP Company Address and Accredited Representative General Product Package Mobiset 4 CAP 910 Components / Scope of Delivery Contents Installation Manual Contents Operating Manual Proper USE USE for the Intended Purpose Proper USE Safety Instructions Important Notes Essential informationAdhesive sealant Road Trafﬁc Licensing Regulations StVZO Power supply, fusing Checks before commencing a journey Unpacking and Preparation Installation and ConnectionSelecting the Installation Location Required Tools and Equipment Direction of travel Installation Steps Figure C Not included Variant with Cable Gland Underneath the Turntable Installation of Turntable Figure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Selection of a Suitable Installation Location Installation of the UFS 940SW Preparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Receiver. There is no restriction on Connection Example for 12 V Battery Connection Reception Range / Footprint ESC Address of the Service CentreDismantling for Servicing Dismantling Manual Lowering to Park Position Safety Instructions Manual Lowering Direction of travel Technical Specifications Potential hazards Sikaflex 291 Safety Data SheetMaterials/preparation and company designation Composition/data on components Exposure limitation and personal protective equipment Measures for ﬁre ﬁghtingMeasures if inadvertently released Handling and storage Stability and reactivity Physical and chemical characteristics Transport data Toxicology data SensitisationEcological data Disposal instructions Other data Sikaﬂex-291 Ikaflex Sikaflex 291 Technical Data Sheet Chemical Stability CAP 910 Operating Manual CAP Remote Control Important Information for CAP 910 Before Setup First Installation Hdmi Video System Automatic clock change summer/winter time Local time offset UTC All satellite positions found by a search will be deleted CAP Menu Turntable Antenna SettingsResetting the CAP System Turntable Antenna Reset Calling UP the CAP Menu Inputting the CAP GPS Position To Move the Antenna ManuallyElevation Stop on Signal LNB TILT/SKEWMove to the Azimuth Rotate the Antenna Search Speed CAP SettingsMove CAP to Park Position Elevation Border and Elevation Offset Countdown for the Search Start Restore Factory Settings Alignment Satellite Search Channel Selection from the Channel List Channel Satellite SELECTION/PROGRAMMING the Timer Channel Selection from the Channel List Sorted by Satellite Timer Programming Change of Location Change of Location Parking the Turntable Park System Protection Messages Special Messages from the Turntable Special Messages from the Turntable Further Messages Messages Arising from Software Problems Timer function is currently not yet available in CAP mode Declaration of Conformity Spent batteries are special waste Disposal Instructions