Installation and Connection | Kathrein cap910 specification

INSTALLATION AND CONNECTION

Initially tighten the coaxial cable plugs ﬁnger-tight, using no tools, then tighten them lightly using an open-ended SW 11 spanner. Do not try to pull the cables from the unit. This could damage the cables or loosen the cable connections.

•Apply a little adhesive sealant to the six threaded holes in the mounting plate and screw the fastening screws into the thread.

Tighten the screws to a torque of 6 Nm.

•Run the connecting cables through the waterproof HDZ 100¹) roof gland into the interior of the vehicle. In so doing the cables may not be crushed, kinked or damaged.

The connecting cables between the turntable and the connecting/control unit may not be extended!

¹) The HDZ 100 roof gland is available as an accessory under part number 20410032 from specialist dealers.

17

Image 17

Kathrein cap910 manual Installation and Connection

Contents

CAP Company Address and Accredited Representative General Product Package Mobiset 4 CAP 910 Components / Scope of Delivery Contents Installation Manual Contents Operating Manual Proper USE USE for the Intended Purpose Proper USE Adhesive sealant Safety Instructions Important NotesEssential information Road Trafﬁc Licensing Regulations StVZO Power supply, fusing Checks before commencing a journey Selecting the Installation Location Installation and ConnectionRequired Tools and Equipment Unpacking and Preparation Direction of travel Installation Steps Figure C Not included Variant with Cable Gland Underneath the Turntable Installation of Turntable Figure E1 Master coaxial cable marked red Version with External Cable Gland FIG. F Installation and Connection Selection of a Suitable Installation Location Installation of the UFS 940SW Preparations Important Instructions for Installation Rear of the receiver Front of the receiver Installation Laying Cables and Connecting the Turntable Installation and Connection Receiver. There is no restriction on Connection Example for 12 V Battery Connection Reception Range / Footprint Dismantling for Servicing Address of the Service CentreDismantling ESC Manual Lowering to Park Position Safety Instructions Manual Lowering Direction of travel Technical Specifications Materials/preparation and company designation Sikaflex 291 Safety Data SheetComposition/data on components Potential hazards Measures if inadvertently released Measures for ﬁre ﬁghtingHandling and storage Exposure limitation and personal protective equipment Stability and reactivity Physical and chemical characteristics Ecological data Toxicology data SensitisationDisposal instructions Transport data Other data Sikaﬂex-291 Ikaflex Sikaflex 291 Technical Data Sheet Chemical Stability CAP 910 Operating Manual CAP Remote Control Important Information for CAP 910 Before Setup First Installation Hdmi Video System Automatic clock change summer/winter time Local time offset UTC Resetting the CAP System Turntable Antenna Reset CAP Menu Turntable Antenna SettingsCalling UP the CAP Menu All satellite positions found by a search will be deleted Elevation Inputting the CAP GPS PositionTo Move the Antenna Manually Move to the Azimuth Rotate the Antenna Stop on SignalLNB TILT/SKEW Move CAP to Park Position CAP SettingsElevation Border and Elevation Offset Search Speed Countdown for the Search Start Restore Factory Settings Alignment Satellite Search Channel Selection from the Channel List Channel Satellite SELECTION/PROGRAMMING the Timer Channel Selection from the Channel List Sorted by Satellite Timer Programming Change of Location Change of Location Parking the Turntable Park System Protection Messages Special Messages from the Turntable Special Messages from the Turntable Further Messages Messages Arising from Software Problems Timer function is currently not yet available in CAP mode Declaration of Conformity Spent batteries are special waste Disposal Instructions