Page

5

WARNING - When using electric products, basic precautions should always be followed, including the following.

WARNING

 )   &.&    & 

  '&) &     

The product should be connected to

#

#

#

 %  %  ) , 

an AC outlet of the specified voltage.

 

 

 



(&&& ) %&)

 

 

 

 



    &)) ,+ %

 

 

 

 

       

Do not insert or disconnect the power

 

 

 

  %   & (

cord plug with wet hands.

 

 

 

 

 

Take care not to allow any foreign

 

 

 

  ,   &)   

matter to enter the product.

 

 

 

 $( ,  & 

 

 

 

 

"&) &  $-)  )) % 

 

 

 

 

) & %  $' ,& *&

 

 

 

 

+& $)  &) 

The chair must be used properly (it must be used only when playing the product).

Do not play with it or stand on it.

Only one person is allowed to sit on it. Do not sit on it when opening the lid. Re-tighten the bolts occasionally.

When using the headphones, do not listen for long periods of

time at high volume levels.

Do not lean against the keyboard.

Do not disassemble, repair or modify the product.

When disconnecting the AC power cord's plug, always hold the plug

and pull it to remove it.

The product is not completely disconnected from the power supply even when the power switch is turned off. If the product will not be used for a long time, unplug the AC power cord from the AC outlet.

  %  &&   +    % $))  %  '

  "    # "& !  

  "  #&    '   "  $

        !      

  "#& (    "  #  " # %   # 

                        

This product may be equipped with a polarized line plug (one blade wider than the other). This is a safety feature.

If you are unable to insert the plug into the outlet, contact an electrician to replace your obsolete outlet.

Do not defeat the safety purpose of the plug.

It is a good practice to have the instrument near the AC outlet and the power cord plug in a position so that it can readily be disconnected in an emergency because electricity is always charging while the plug is in the AC outlet even in a power switch off condition.

Page 5
Image 5
Kawai CN33 manual Product should be connected to