ASSEMBLY INSTRUCTIONS
Caution y Ensure that this instruction manual is read thoroughly before attempting to assemble the CN33 digital piano, and that two or more people work on assembly.
yIt may be necessary to tilt the unit by 90 degrees while assembling the CN33 digital piano. During this time, ensure that hands are not caught in the piano, keyboard lid, or score stand, and that the piano is not dropped on an individual’s feet.
PARTS PROVIDED
Before attempting to assemble the CN33 digital piano unit, ensure that all parts are included. A
(A) Piano (x 1)
(B) Pedal board (x 1) | (E) | (F) | (G) | (H) | (I) | (J) | (K) |
Adjuster bolt | I4 x 16 | I4 x20 | I4 x30 | M6 x 25 | Cord clamp | Headphone hook and screws | |
(C) End panel (x 1 each for left and right) |
|
|
|
|
|
|
|
(D) Back panel (x 1) |
|
|
|
|
|
|
|
(E)Adjuster bolt (x 1)
(F)Screw: I4 x 16 (x 4) (Silver)
(G) Screw: I4 x 20 (x 4) | Screw | |
(x 2) | ||
(H) Screw: I4 x 30 (x 4) | ||
|
(I)Screw: M6 x 25 (x 4)
(J)Cord clamp (x 2)
(K)Headphone hook and screws (x 1 set)
(L)Power cord (x 1)
ASSEMBLY SEQUENCE
8 | APPENDICES |
|
Caution y Be careful not to scratch or damage the floor, piano, or stand at the time of assembly.
1.Screw the adjuster bolt (E) into the threaded screw hole provided in the base of the pedal board.
2.Attach the pedal board (B) and end panels (C), sliding the front of the pedal board into the notch in the end panels. Ensure the metal bracket on the base of the end panel slides beneath the
3.Hold the pedal board (B) and end panels (C) together, then tighten the
4.Unfasten and extend the pedal connection cable attached to the bottom of the pedal board.
5.Attach the back panel (D) to the stand assembly using screws
(G) and (H) in the prepared holes. Loosely tighten the screws with the * symbol.
1
(E)
2 y 3 | (F) |
| |
|
(F)
(C)
(B)
4 y 5
(D) |
|
| (H)* |
|
| (H)* | |
(H)*(H)* | (G) | (G) | |
(G) | (G) | ||
|
|
|
Unfasten and extend the pedal cable
