zEFFECTS
The EFFECTS function adds chorus, delay, tremolo, and rotary speaker simulation effects to the sound (page 20).
zBALANCE
The BALANCE slider is used to adjust the volume balance between the two sounds in Dual or Split modes, and also controls the volume of left and
Page
9
NAMESPART AND FUNCTIONS | 1 |
|
z METRONOME
The METRONOME function provides a
steady beat with which to aid piano practice. | z POWER SWITCH |
The tempo, time signature, and volume | The POWER SWITCH is used to turn the |
of the metronome can be freely adjusted | CN33 digital piano on and off. Be sure to turn |
(page 22). | off the instrument after playing (page 10). |
z REVERB | z SPLIT |
The REVERB function adds reverberation | The SPLIT function divides the |
to the sound, simulating the acoustic | keyboard into two sections— |
environment of a recital room, stage, or | Upper and Lower— allowing |
concert hall (page 19). | each section to be played with |
| a different sound (page 15). |
zRECORDER
The REC button is used for recording performances and when using the Lesson function, to record practices for comparison with the
zTRANSPOSE
The TRANSPOSE function allows the audible pitch of the CN33 digital piano to be raised or lowered in half steps (page 21).
zUSB
The USB functions allow recorder songs to be saved to and loaded from a USB memory device (page 38).
zFUNCTION
Pressing the TRANSPOSE and USB buttons simultaneously enters the FUNCTION modes, allowing various advanced parameters of the CN33 digital piano to be adjusted (page 43).
HEADPHONES AND USB CONNECTORS
¡ Headphone jack (x 2)
There are two headphone jacks located on the left underside of the piano.
Up to two pairs of headphones can be connected simultaneously. For information on attaching the headphone hook, please refer
to the assembly instructions on page 66.
¡ USB (to device)
The USB (to Device) connector is located beside the two headphone jacks, and used to load and save recorder songs to a USB memory device (page 38).
