6.Place the stand upright so that the backside of the stand assembly rests against a wall, then slowly and carefully insert the piano. Ensure that more than two people work on the assembly. If attempting to insert the piano without resting the stand against a wall, support the back of the stand using your foot or leg to prevent the stand from sliding backwards.
Caution y Ensure that the piano is not dropped on an individual’s feet, and that fingers, hands and
feet are not caught in the piano.
7.Fasten the piano (A) to the stand with four screws (I).
Caution y Ensure that the piano and the stand are securely fastened together with the correct
screws to prevent the possibility of the piano falling.
8.Fix the headphone hook and screws (K) if desired.
9.Tightly fasten the screws (H) (with the * symbol in step 5).
10.Insert the connector of the pedal cord into the receptacle, and fix the cord with the cord clamp (J).
Page
67
6 y 7 y 8
(A)
(K)
(I)
(I)
9 y 10
Protrusion
(J)(J)
(H)*
11.Turn the adjustor bolt (E) at the bottom of the pedal stand until the bolt firmly touches the floor, supporting the pedal board.
Caution y Ensure that the adjuster bolt (E) firmly touches the floor, supporting the pedal board
and preventing damage.
When moving the piano, shorten the adjustor bold (E) and readjust after moving has been completed.
12.Connect the power cable (K) to the AC IN terminal on the base of the main body, then pass the cable through the back board aperture, and out to the rear of the instrument.
11 |
(E) |
12 |
(L) |
13. Remove the protective film from the display. | 13 |
APPENDICES
8
