Kenmore 790.3671 manual Surface Cooking contd, Before Setting, Oven Controls, Using the Griddle

Models: 790.3671 790.367

1 46
Download 46 pages 51.78 Kb
Page 14
Image 14
Surface Cooking (cont'd)

Surface Cooking (cont'd)

Care & Seasoning of the Griddle

Before first use:

Wash Griddle in hot soapy water. Rinse and then dry completely.

Apply a thin coat of vegetable oil to the entire surface (front and back of griddle). = Preheat your oven to 350°E Place the griddle on the upper rack in your oven.

Bake griddle for 1 hour at 350°F, then turn oven OFF and let cool before remov- ing.

The surface may appear to have a tacky feel to it from the seasoning process. If desired, wash the griddle in hot soapy water, rinse well, and dry completely.

After each use:

=To prevent rusting, store in a dry place and keep uncovered. After each use, clean with a stiff brush and hot water only.

DO NOT CLEAN GRIDDLE IN DISHWASHER.

Dry Immediately and apply a light coating of vegetable oil to griddle before storing.

Using the Griddle:

=Place either side of the griddle centered over the left side gas burners or over the Bridge Burner. For location refer to Figure 1.

• Preheat the griddle for 5 minutes on medium to medium low setting. Slow

Figure 1

preheat ensures even heat distribution during the cooking process.

 

DO NOT preheat the griddle on Hi setting. Preheating on HI may warp the griddle and prevent even heat distribution.

Before Setting

Oven Controls

_This

range has afan that will turn "ON" and "OFF" by itself to keep the electronics cool. it may continue

to run after the range has been turned "OFF", but may also stop immediately and then turn "ON" after a while.

Oven Vent Location

The oven vent is located in the center rear on the cooktop. When the oven is on, warm air passes through the vent. This venting is necessary for proper air circulation in the oven and good baking results. DO NOT BLOCK OVEN VENT. Never close off the openings with aluminum foil or any other material.

Removing and Replacing Oven Racks

To remove, pull the rack forward until it stops. Lift up front of rack and slide out. To replace, fit the rack onto the guides on the oven walls. Tilt the front of the rack upward and slide the rack back into place.

OVEN VENT

i

14

Page 14
Image 14
Kenmore 790.367 Surface Cooking contd, Before Setting, Oven Controls, Care & Seasoning of the Griddle, Using the Griddle