Kenmore 790.3671 Self=Cleaning, contd, Self-CleanCycle Time Length, Instructions, Press, Display

Self=Cleaning	(cont'd)
Self-Clean Cycle Time Length
The FLEX CLEAN _	pad is used to start a Self-Cleaning cycle. When used with the DELAY START	pad, a

delayed Self Cleaning cycle may also be programmed. The FLEX CLEAN feature allows for any Self-Cleaning cycle time from 2 (2:00) to 4 hours (4:00) to be selected. You may also choose the clean time in 1 minute increments (for example 2

hours and 50 minutes)by pressing the number keypads _ _ _.

During the Self-Cleaning cycle, the outside of the range can become very hot to the touch. DO NOT leave

small children unattended near the appliance.

DO NOT force the oven door open. This can damage the automatic door locking system. Use care when

opening the oven door after the Self-Cleaning cycle. Stand to the side of the oven when opening the door to allow hot air or steam to escape. The oven may still be VERY HOT.

INSTRUCTIONS PRESS DISPLAY

To set an immediate Self-Cleaning Cycle or to set a delay start time of 9:00 o'clock (example: default 3 hour Self-Clean cycle)

t.Be sure the clock is set with the correct time of day, the oven is empty and the oven door is dosed.

2. Press_.	"CLEAN"		will flash and		"3:00"	HR will show in the			_.'F.L_AXN_
display (Figure 1). 2-4 hours of Self-Cleaning time may be chosen
by pressing	any amount		of time from _		@		@	(2 hours)	Figure 1
through _	@	@	(4 hours)	in one minute			increments.
You may also skip the time entry and accept the default cleaning
time of 3 hours by pressing the Start key pad (See Step 3).									Figure 2
3. Press _A_."DOOR",			"LOCKED"	will flash;		"CLEAN"		and the
letters "CLn" will remain on in the display (Figure 2).

4.As soon as the control is set, the motor driven oven door lock will begin to close automatically. Once the door has been locked the

"DOOR", "LOCKED" indicator light will quit flashing and remain on. Note: Allow about t 5 seconds for the oven door lock to close.

Note: If the optional delay Self-Clean feature is needed, finish steps 5-7. If Self-Clean is started immediately skip the remaining steps and continue with "When the self-clean cycle is completed" on the following page.

5.Press (,_,_j) (see Figure 3). Enter the desired Self-Clean starting

time using the number pads @ @ @ (See figure 4).

6. Press@.	"DELAY", "DOOR", "LOCKED", "CLEAN"	will
remain on and the display returns to the time of day.

7.Based on the time amount you selected in step 2, the control will calculate forward from the set start time to determine when the Self-Cleaning cycle should end. The Self-Cleaning cycle will turn on automatically at the set time. At that time the icon "DELAY" will go out; the oven icon will come on, "CLEAN" and "CLn" will remain in the display (see Figure 5).

Figure 3

Figure 4

When the Self-Clean Cycle is Completed

1. The time of day, the "DOOR", "LOCKED" and "CLEAN" icon will	Figure 5
remain in the display.

2.Once the oven has cooled down for approximately 1 HOUR, and the "DOOR", "LOCKED" icon is no longer displayed, the oven door can then be opened.

37