Kenmore 790.3671 manual Setting Oven Controls, Instructionspress

Setting Oven Controls

Setting the Clock

The CLOCK _ pad is used to set the clock. The dock may be set for 12 or 24 hour

time of day operation. The clock has been preset at the factory for the 12 hour operation. When the range is first plugged in, or when the power supply to the range has been interrupted, the timer in the display will flash with "PF" (power failure, See Figure 1).

When PF appears in the display, press _. No sound will be heard, but after 10 seconds

a beep will sounds and PF will disappear.

INSTRUCTIONSPRESS

To set the clock (example: 1:30)

1.	Press	_.	"CLO"		will appear in the display (Figure		2).	Q
2.	Press	(_	(_	(_	pads to set the	time of day to 1:30		OQQ
	(Figure	3). "CLO"		will stay in the display.		Press _r_.	"CLO"

will disappear and the clock will start (Figure 4).

Figure 1

DISPLAY

Figure 2

Figure 3

Changing between 12 or 24 hour time of day display

1. Press and hold _ for 7 seconds (Figure 3). CONTINUE

holding the pad until "12Hr" (Figure 4) or "24Hr" (Figure 5) appears in the display.

2. Press _ to switch between the 12 and 24 hour time of day

display. The display will show either "12Hr" (Figure 4) or "24Hr" (Figure 5).

3.Press <A_ to accept the desired change or press @ to reject the change.

4.Reset the correct time as described in To set the Clock above. Please note that if the 24 hour time of day mode was chosen, the clock will now display time from 0:00 through 23:59 hours.

Q

for 7 seconds

Q

:'itt

Figure 4

Figure 5

17