Kenmore 790.75503 manual Changing Oven Light Adjusting Oven Temperature, To Change the Oven Light

Changing Oven Light

Adjusting Oven Temperature

NOTE: The adjustments made will not change the self-cleaning temperature.

Be sure the oven is unplugged and all parts are COOL before replacing the oven light bulb. Do not turn the oven light on during a self-cleaning cycle. High temperature will reduce lamp life.

To Change the Oven Light

The oven light automatically turns on when the door is opened (some models). To turn the oven light on and off when the door is closed, use the OVEN LIGHT switch located on the control panel.

I.Turn electrical power off at the main source or unplug the oven.

2.Wear a leather-faced glove for protection against possible broken glass.

3.Presswire holder to one side to release the glass shield.

4.Replace bulb with a new 40 watt appliance bulb.

5.Replace glass shield in socket and snap wire holder into place.

6.Turn power back on at the main source (or plug the appliance back in).

7.The clock will then need to be reset. To reset, see Setting the Clock and Minute Timer in the ELECTRONICOVEN CONTROL section of this manual.

When first using the oven, be sure to follow recipe times and temperatures. If you think the oven is too hot or too cool, the temperature can be adjusted. Before adjusting the oven temperature, test a recipe by using a temperature set higher or lower than the recommended temperature. The baking results should help you to decide how much of an adjustment is needed.

To Adjust the Oven Temperature:

I.Push BAKE.

2.Set the temperature to 550°F/288°C by pushing the UP ARROW.

3.Within 2 seconds, push and hold BAKE for approximately 5 seconds until the special 2 digit display appears. ReleaseBAKE. The display now indicates the difference in degrees between the original factory temperature setting and the current temperatu re setting. If the oven control has the original calibration, the display will read "00".

4.The temperature can now be adjusted up or down 35%/21°C, in 5°F/3°C increments, by pushing the UP or DOWN ARROW. Adjust until the desired amount of degrees offset appears in the display. When adjusting for a cooler temperature, a minus sign (-) will appear before the number in the display.

5.When you have made the desired adjustment, push CLEAR OFF to go back to the time of day display.

36