Youmaysavethecostandinconvenienceof anunnecessarservicecallbyfirstreviewingthis Checklistofcommonlyencounteredproblemsituations.
Youwillbechargedforaservicecallwhiletheapplianceisinwarrantyiftheproblemisnot causedbydefectiveproductworkmanshipmaterials.
Avoid Service Checklist
Your new appliance is a carefully engineered product. Many times, what appears to be a reason to call service requires nothing more than a simple adjustment you can easily make in your own home.
OCCURRENCE | POSSIBLE | CAUSE/SOLUTION |
|
|
| |||
Range is not meveE | Poor installation. | To | level | range, | refer to | Leveling Guide, page | 8 in the | Installation |
| Instructions. When | range | is level, | cooktop | may appear out of | alignment | if countertop is | |
| not level. |
|
|
|
|
|
|
|
Cannot move appliance easily. Appmiance must be accessibme for service.
Entire range or oven does not operate.
Weak, unstable floor. Be sure floor is level and can adequately support range. Contact a carpenter to correct sagging or sloping floor.
Kitchen cabinet misalignment may make range appear to be unlevel. Be sure cabinets are square and have sufficient room for range clearance.
Cabinets not square or are built in too tight. Contact a cabinet maker to correct the
problem.
:i
Contact builder or installer to make appliance accessible. | '_:_ |
Carpeting interferes with range. Provide sufficient space so range can be lifted over carpet.
Make sure cord/plug is tightly into outlet.
Service wiring is not complete, Contact your dealer, installing agent or authorized servicer.
*Oven control beeps and displays F1, F3 or Fg.
Oven and/or cooktop lights does not work.
Surface unit does not heat.
Surface burners do not light.
Power outage. Check house lights to be sure. Call your local electric company for service.
Electronic control has detected a fault condition. Push CLEAR to clear the display and stop beeping. Program oven again. If fault recurs, record fault number. Push CLEAR and contact an authorized servicer.
Replace or tighten bulb. See "Changing Oven Light" in this Guide for instructions.
No power to the appliance. Check steps under "Entire Range or Oven Does Not Operate" in this Avoid Service Checklist.
Incorrect control setting. Make sure the correct control is on for the surface unit to be used.
Surface control knob has not been completely turned to LITE. Push in and turn the
surface control knob to LITE (until burner ignites) and then turn the surface control knob to the desired flame size.
Burner ports are clogged. Clean burners. See "To Clean Burner Grates, Contoured Burner Pans, Burner Cap and Burner Base" under General Cleaning. With the burner off, use
Surface burner flame burns half way around.
Gas supply is turned off. Turn gas supply on.
Burner ports or slots are clogged. With the burner off, clean by using a
Moisture is present after cleaning, Lightly fan the flame and allow the burner to operate
until flame is full. Dry the burners thoroughly following instructions under General
Cleaning.
37
