Kenmore 790. 9802 manual Setting Surface Controls contd, Operating Single Radiant Surface Elements

Setting Surface Controls (cont'd)

Operating Single Radiant Surface Elements

The cooktop has 3 SINGLE radiant surface elements: the RIGHT REAR position LEFT FRONT position and the LEFT REAR position (Figure 1).

To Operate the Single Radiant Surface Elements:

1.Place correctly sized cookware on the radiant surface element.

.	Touch and hold the			pad for the desired element position until a beep
	is heard. The display will show " -- "
	Note: If no further pads are touched within 10 seconds the request to power
	the element ON will clear.
.	Touch HI _	pad once		to turn ON the power		level to HI. Touch Lo
	pad once for Lo (See Figure 3). The Hot Surface indicator light will turn ON
	when the element		becomes	hot.
.	Each touch of the		HI C_	or Lo _	pad will decrease or increase the
	power level from 9.0 through 3.0 by .5 increments. Simmer power levels
	between 3.0 and 1.2 will decrease or increase by .2 increments. Lo is the
	lowest power	level available.
	Note: The power level may be adjusted at any time while the element is ON.
5. When cooking		has been completed			touch the	pad once to turn the
	element OFF.

Each surface element provides a constant amount of heat at each setting. A glowing red surface heating area extending beyond the bottom edge of the cookware indicates the cookware is too small for the surface heating area.

Note: The Hot Surface message will remain displayed on the control panel as long as the element is still hot and will remain ON until the heating surface area has cooled sufficiently.

Radiant surface elements may appear to have cooled after they have been turned off. The glass surface may still be hot and burns may occur if the glass surface is touched before it has cooled sufficiently.

Do not place plastic items such as salt and pepper shakers, spoon holders or plastic wrappings on top of the range when it is in use. These items could melt or ignite. Potholders, towels or wooden spoons could catch fire if placed too close to the surface elements.

Figure 1

Right Rear, Left Rear & Right Front

Elements

iiil...............

...........ii

V

Figure 2