The display shows:
Check if...
BEFORE CALLING FOR SERVICE (cont.)
I ##I-u,:| Then...
Loadis too small. Add 1or 2 similar itemsto help balancethe load.
Loadis out of balance. Pausethe cycle and redistribute the load after the door unlocks.
The display shows: I _L'_-I
Check if...
Controlerror.
Thewasher has an imbalance detection and correction system. If
individualheavy articles are loaded(bath mat, bath robe, etc.) and
theimbalance is too great, the washer will make severalattempts to
restartthe spin cycle. Ifan imbalance is still detected, the washer wilt
stopand the errorcode wiltbe displayed.
Then...
Unplugthe washerand wait 60 seconds. Reconnect power and try
again.If the error reappears, call for service.
The display shows: r J- |
I-I--
Check if...
Water level is too high due to afaulty watervalve.
The display shows: n_-
I-I--
Check if...
Thewater levelsensor isnot workingcorrectly.
The display shows: nn-
LL-"
Check if...
Thermaloverload protectioncircuit inthe motor has been
tripped.
The display shows: IPF
Check if...
A powerfailure has occurred.
Then...
Closethe water taps, unplug the washer, and call for service. [
I
Then...
Closethe water taps, unplug the washer, and call for service. [
I
Then...
Allowthe washer to stand for 30 minutes to allow the motor to coot;
thenrestart the cycle. Ifthe LE error code persists, call forservice.
Then...
Ifthe power tothe washer has been interrupted during a cycle,the
"PF"error code wilt be displayed the next time the washer is turned
ON.This wiltalert you to the fact that the previous cycle may not
havebeen completed. Select any cycle to clear the error codeand
usethe washer.
28