System connections
SYSTEM CONTROL CONNECTIONS
Connecting system control cords after connecting a KENWOOD audio component system lets you take advantage of convenient system control operations.
There are two KENWOOD system control modes. Make connec- tions according to the groups of terminal symbols shown below.
[XS 8] Mode : lets you combine F, f, and Äterminals
[SL16] Mode : for 
terminals only
This unit is compatible with both [XS8] and [SL16] modes. Select the mode according to the connected components. 4
j
SL16 XS 8
ÖDo this operation after completing all connections. (Ensure that the unit is set to STANDBY mode.)
Amplifier or receiver
SYSTEM
CONTROL
This unit
SYSTEM
CONTROL
Cassette deck
SYSTEM
CONTROL
5
Notes
1. If your amplifier or receiver does not have a system control terminal, do not connect any system control cords to the system control terminals on the other components.
2. Do not connect system control cords to any components other than those specified by KENWOOD. It may cause a malfunction and damage your equipment.
3.Be sure the system control plugs are inserted all the way in to the system control terminals.
SYSTEM CONTROL OPERATIONS
Remote Control
Lets you operate this unit with the system remote control unit supplied with the amplifier or receiver.
Automatic Operation (Except [XR] equipment)
Automatically switches the input selector on the amplifier or receiver when you start playback from this unit.
Synchronized Recording (Except [XR] equipment)
Lets you synchronize recording with the start of playback when recording from a CD. Also, the simple CCRS operation enables great recordings from CDs.
See the operating instructions supplied with your cassette deck for details.
Adjusting the output levels of the output jacks and headphone output (Except for
The OUTPUT level (UP/DOWN) keys of the remote control unit can adjust the output levels from the LINE/OUT and PHONES jacks of the unit.
OUTPUT
DOWN UP
ÖIt is not favorable for the sound quality to decrease the output level from this unit too much. Use these keys for coordination with other line levels.
ÖAdjusting the headphone output level also changes the LINE/OUT level. Do not adjust the output level from this unit particularly during recording.
ÖPlease note that the sound output is at the maximum level when the power is turned on.
To use the headphone (Except for CD-203/DPF- R3010)
Connect a stereo headphone to the PHONES jack of the CD player. Adjust the sound volume using the remote control unit.
Output level
OUTPUT -12dB
1 2 3 4 5
6 7 8 9 10
_1 2 d b
Output level
