Kenwood KDC-MP819, KDC-X659, KDC-X559, KDC-719 instruction manual Adjustment

Adjustment			Item	Display		Range
Bass Center			Frequency*	“Bass	FRQ”	60/70/80/100 or 150 Hz
Bass	level		L	“Bass”		-8-+8
Bass	Q Factor*			“Bass	Q”	1.00/1.25/1.50/2.00
Bass Extend*				“Bass EXT”		ON/OFF
Middle		Center		“MID	FRQ”	0.5/l .0/l .5/2.0 kHz
Frequency*
Middle		level		“MID”		-8-+8
Middle		Q Factor*		“Middle Q”		1.0/2.0
Treble		Center	Frequency*	“TRE FRO”		10.0/12.5/15.0/17.5 kHz
Treble		level		“TRE”		-8-+8
Balance				“Balance”		Left 15 - Right 15

Function ofthe KDC-MPSlS/KDC-71:

Fine-tuning so that the System Q value is optimal when setting the speaker type.

1 Enter Standby

Press the [SRCI button. Select the “ALL OFF” display.

2 Enter Speaker Setting mode Press the IQ] button. “Speaker Setting” is displayed.

Fader		“Fader”	Rear 15 - Front		15
NonFadIng	level*	“NF Level”	-15-+I5
Front Hugh Pass Filter*		“HPF Front”	Through/40/60/80/i		001
			120/150/180/220		Hz
Rear High	Pass Filter*	“HPF Rear”	Through/40/60/80/i		OO/
			120/150/180/220		Hz
Non-Fading		“LPF NF”	50/80/l	20/Through Hz
Low Pass Filter*
Non-Fading	Phase*	“NF Phase”	Normal	(O”)/Reverse
(180")
Volume offset		“Volume Offset”	-8 -	*O

l According to the Bass 0 Factor setting value, the frequencies that can be set in Bass Center Frequency change as shown below.

Bass 0 Factor	Bass Center Frequency
1.00/l .25/l .50	60/70/80/l	00
2.00	60/70/80/l	50

l When the bass extend is set to ON, low frequency response IS extended by 20%.

l Volume offset: Each source’s volume can be set as a difference from the basic volume.

l* :Function of the KDGX659 / KDGX559

5 Exit Audio Control mode Press the [AUDI button.

-ll-

3 Select the Speaker type Press the [I-Ior [WI button.

Each time the button is pressed the below.

Speaker type

OFF

For 5 & 4 in. speaker

For 6 & 6x9 in. speaker

For the OEM speaker

4 Exit Speaker Setting mode Press the [Ql button.

setting switches as shown

Display “OFF” “5/4 inch” “6+9/6 inch” “O.E.M.”