n Installation
Flrew~lll or metal support
Screw (M4X8) (commercially ava;lable)
n Installing in Japanese-Made Cars
1 R&z to the section “Removing the hard rubber frame” (page 35)
and then remove the hard rubber frame.
2 Align the holes in the unit (two locations on each side) with the
vehicle mounting bracket and secure the unit with the accessory screws.
/\
/\
screw | Metal mounting strap | |
(commercially | available) | (commercially available) |
Bend the tabs of the mounting sleeve with a screwdriver or similar utensil and attach It I” place.
T Toyota cars
N: Nissan carsAccessory@...for Nissan car Accessory@ ...for Toyota car
During installation, do not use any screws except for those provided. A l The use of different screws might result In damage to the maln unit.
lDamage may occur if a screwdriver or similar tool is used with excessive force during the installations.
@Make sure that the unit is installed securely I” place. If the unit is unstable, It may malfunction (for example, the sound may skip).
n Screwing the Faceplate on the Unit
If you want to fasten the faceplate to the main unit so that it does not fall off, screw in the provided screws (04 X 16 mm) in the holes shown below.
Never insert the taptite screw (04 x 16 mm) in any other screw hole
Athan the one specified. If you screw it in another hole, it will contact and may cause damage to the mechanical parts inside the unit.
- 34 -