Accessories
External view | External view |
......... Number of items | ......... Number of items |
Installation Procedure
1. | To prevent a short circuit, remove the key from the ignition and |
| disconnect the - battery. |
2. | Make the proper input and output wire connections for each unit. |
3. | Connect the speaker wires of the wiring harness. |
1
2
3
4
5
6
2CAUTION
.........1 | 7 | 1 |
|
| |
.........1 | 8 | 1 |
......... | ||
.........2 | 9 | 1 |
| ......... | |
.........1 | 0 | 1 |
......... | ||
.........2 |
|
|
.........2 |
|
|
4. | Connect the wiring harness wires in the following order: ground, |
| battery, ignition. |
5. | Connect the wiring harness connector to the unit. |
6. | Install the unit in your car. |
7. | Reconnect the - battery. |
8. | Press the left part at the upper side of the faceplate once to |
| make the faceplate control panel appear. |
2CAUTION
• If your car's ignition does not have an ACC position, connect |
the ignition wires to a power source that can be turned on |
and off with the ignition key. If you connect the ignition wire |
to a power source with a constant voltage supply, as with |
battery wires, the battery may die. |
• If the console has a lid, make sure to install the unit so that |
the faceplate will not hit the lid when closing and opening. |
• If the fuse blows, first make sure the wires aren’t touching |
to cause a short circuit, then replace the old fuse with one |
with the same rating. |
• Do not let unconnected wires or terminals touch metal on |
the car or anything else conducting electricity. To prevent a |
short circuit, do not remove the caps on the ends of the |
unconnected wires or the terminals. |
• Connect the speaker wires correctly to the terminals to |
Do not use any accessories other than those provided with your unit. If you use other accessories, you may damage the
which they correspond. The unit may be damaged or fail to |
work if you share the - wires or ground them to any metal |
part in the car. |
• After the unit is installed, check whether the brake lamps, |
blinkers, wipers, etc. on the car are working properly. |
• Insulate unconnected wires with vinyl tape or other similar |
material. |
• Some disc changers need conversion cords for connection. |
See the section on "Safety Precautions" for details. |
• Mount the unit so that the mounting angle is 30° or less. |
— 43 —
