PROBLEM | POSSIBLE CAUSE | SOLUTION | |
|
|
| |
No sound can be heard, or the | Attenuator is turned on. | Turn off Attenuator. | |
volume is low. |
|
| |
The fader or balance settings are set all the way to one | Reset the fader or balance settings. | ||
| |||
| side. |
| |
|
|
| |
| The input/output wires or wiring harness are connected | Reconnect the input/output wires or the wiring harness | |
| incorrectly. | correctly. See the section on "Connecting Wires to | |
|
| Terminals". | |
|
|
| |
| The values of Volume offset are low. | Increase the values of Volume offset. (see p. 18) | |
|
|
| |
The sound quality is poor or | One of the speaker wires is being pinched by a screw in | Check the speaker wiring. | |
distorted. | the car. |
| |
|
|
| |
| The speakers are not wired correctly. | Reconnect the speaker wires so that each output | |
|
| terminal is connected to a different speaker. | |
|
|
| |
A CD ejects as soon as it is | The CD is | Load the CD with the labeled side up. | |
loaded. |
|
| |
The CD is quite dirty. | Clean the CD, referring to the section on "Cleaning CDs" | ||
| |||
|
| (see p. 6). | |
|
|
| |
The sound skips on a CD. | The CD is scratched or dirty. | Clean the CD, referring to the section on "Cleaning CDs" | |
|
| (see p. 6). | |
|
|
| |
A track will not play. | Random play has been selected. | Turn off random play. |
Can’t remove disc.
The cause is that more than 10 minutes has elapsed since the vehicle ACC switch was turned OFF.
The disc can only be removed within 10 minutes of the ACC switch being turned OFF. If more than 10 minutes has elapsed, turn the ACC switch ON again and press the Eject button.
