SCAN
Scan is useful for monitoring signals on the transceiver channels. While scanning, the transceiver checks for a signal on each channel and only stops on a channel if a signal is present.
To begin scanning, press the key programmed as Scan.
•On K2/K3/K5/K6/K7 model transceivers, the 
icon appears on the display.
•The channels included in the scan list are scanned.
•When a signal is detected on a channel, Scan pauses on that channel. The transceiver will remain on the busy channel until the signal is no longer present. When the signal “drops out”, the transceiver will remain on the channel momentarily before Scan resumes. This delay time is programmed by your dealer. If a signal is received during the delay time, the transceiver will remain on the same channel.
To stop scanning, press the Scan key again.
Note: In order for Scan to operate, there must be at least 2 channels added to the scanning sequence. If there are less channels than this, Scan will not operate.
Temporary Channel LockoutIf a key is programmed with the Scan Delete function, each channel can be locked out of the scan sequence manually.
During scan, you can temporarily remove specific channels from the scanning sequence by selecting them and pressing the Scan Delete key.
•On K2/K3/K5/K6/K7 model transceivers, the 
icon no longer appears on the display for that channel.
•The channel is no longer scanned. However, when scanning is ended and restarted, the channels will reset and the channel will again be in the scanning sequence.
24