6 COMMUNICATING
Each mode used on the HF Amateur bands has its own advantages. Although long distance DX contacts may be less common while using AM, the superior audio quality characteristic of AM operation is one reason why some prefer this mode.
When looking for others using AM, check the following frequencies first:
¥3885, 7290, 14286, 21390, and 29000~29200 kHz
Refer, if necessary, to ÒOPERATING BASICSÓ beginning on page 19 for complete receiving details for any mode.
1Select the operating frequency.
2Press [FM/AM] to select AM mode.
AGC AUTO
AM
3Select the ALC meter function by pressing [METER].
4Press and hold down the Microphone [PTT] switch, or press [SEND].
¥The ÒON AIRÓ indicator lights.
¥Refer to ÒVOXÓ {page 45} for information on automatic TX/RX switching.
5Without speaking, adjust the CAR control so that the ALC meter just begins to indicate.
6Speak into the microphone and adjust the MIC gain control so that only a few segments on the ALC meter light.
¥Speak in a normal tone and level of voice. Speaking too close to the microphone, or too loudly, may increase distortion and reduce intelligibility.
7If you want to use speech processing, press [PROC] to switch on the Speech Processor and adjust as described on page 46.
8Release the Microphone [PTT] switch, or press [SEND] again, to return to the receive mode.
¥The ÒON AIRÓ indicator goes out.
This completes the ÒAM TRANSMISSIONÓ section. Refer to ÒOPERATING AIDSÓ beginning on page 44 for information about additional useful functions for operating.
Since Multimode Communications Processors (MCP) have become popular, many Amateurs enjoy operating using a number of digital modes. The power and variety of Amateur radio increased greatly with the development of MCP that can use your
For example, itÕs possible to take advantage of the camaraderie found on RTTY, then move to Packet to access an RBBS (Radio Bulletin Board System) to download a recent shareware program youÕve heard about, and then move again to AMTOR or PacTOR to deposit mail in a regional mailbox for forwarding. After that, you may switch to
Consult ACCESSORY CONNECTIONS {pages 5~7} before proceeding if you need installation information. It is assumed here that you have all hardware, and software if necessary, already correctly installed.
Important Menu items to be aware of before beginning to operate RTTY include the following:
¥Menu No. 62 (FSK.SHFT): Selects 170, 200, 425, or 850 Hz shift. The 170 Hz shift default is used on the Amateur bands.
¥Menu No. 63 (MARK.POL): Allows reversal of the
¥Menu No. 64 (FSK.TONE): Switches between a high tone (2125 Hz) and a low tone (1275 Hz). The default is 2125 Hz. The high tone is commonly used nowadays.
1Select the operating frequency.
2Press
AGC AUTO
FSK
3Select the ALC meter function by pressing [METER].
S | 1 | 3 | 5 | 7 | 9 | 20 | 40 | 60 | dB |
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
| ||
|
| 10 |
| 25 | 50 |
| 100 |
|
|
| 0 |
|
| FILTER |
| W | |||
|
|
| ALC |
|
|
|
|
|
|
40