1Remove the screws (10 screws).
2Lift off the top case.
1Remove the screws (12 screws).
w
CN901
Cover A
q
CN5 | CN5 |
4
5Replace the bottom case and
CAUTION: Switch OFF the power and unplug the DC power cable before beginning installation.
EQUIPMENT REQUIRED:
•Large Phillips screwdriver
•Small Phillips screwdriver
1Confirm that the small switch on the
2Remove the bottom case (12 screws).
3Remove Cover A (7 screws).
2Lift off the bottom case.
CAUTION: Switch OFF the power and unplug the DC power cable before beginning installation.
ENGLISH
CN6
Cover A
Note: Refer to ÒINTERNAL ADJUSTMENTSÓ {page 70} for information on adjusting the recording level.
EQUIPMENT REQUIRED:
•Large Phillips screwdriver
•Small Phillips screwdriver
1Remove the bottom case (12 screws).
2Remove Cover A (see diagram) (7 screws).
3Locate the CN5 connector in the transceiver. Remove the paper backing from one side of the supplied cushion, then install the cushion. Remove the paper backing from the other side of the installed cushion, then plug the
4Locate theCN6 cable in the transceiver, and plug this cable into the
Threaded | Threaded | |
| post | |
post |
| |
|
|
CN6
75