2INSTALLATION
If using an external
Connect a cable from the IF OUT 1 jack to the IF IN jack on the
To Antenna
|
If you intend to use this transceiver for any of the digital modes, connect the input/output connections from a Terminal Node Controller (TNC) for Packet operation, a Multimode Communications Processor (MCP) for operation on Packet, PacTOR, AMTOR,
SSTV and phone patch equipment can also be connected to ACC 2. SSTV operation is possible by connecting the input/output from a computer sound card to ACC 2, then running an SSTV application on the computer.
To operate on the digital modes, you will need the following equipment:
¥Personal computer with communications software (alternatively, a ÒdumbÓ terminal capable of sending ASCII commands)
¥TNC (Terminal Node Controller) or MCP (Multimode Communications Processor)
¥TNC or MCP power supply
¥
¥
Connect your TNC or MCP to the ACC 2 connector on the transceiver Rear Panel using a cable equipped with a
Do not share a single power supply between the transceiver and the TNC or MCP. Keep as wide a separation between the transceiver and computer as practical to reduce
6