Digital Crossover Network

Adjust various parameters of the Crossover network.

1Press the AUD button repeatedly and switch the display to “X’OVER CTRL” to enter the Crossover network control mode. Pressing the button cycles through Audio control mode, Crossover control mode, and Control mode off.

2Selecting mode

Press either the FM or AM button.

Each time the button is pressed, the adjustment mode will change.

Please refer to the following for the contents of the adjustment modes.

3Adjust each mode

Press the 4/¢ button.

Please refer to the following for the adjusting values.

4Press the AUD button once to end the Crossover network control mode.

"HPF F" : Adjust the frequency of the High-pass filter for front output.

Setting values: THROU / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output,including preouts. The high-pass filter does not affect the non-fading preout.

"HPF R" : Adjust the frequency of the High-pass filter for rear output.

Setting values: THROU / 40Hz / 60Hz / 80Hz / 100Hz / 120Hz / 150Hz / 180Hz / 220Hz

NOTE

You can separately set the high-pass filter for front and rear output, including preouts. The high-pass filter does not affect the non-fading preout.

"LPF NF" : Adjust the frequency of the Low-pass filter for Non- Fading output.

Setting values: 50 Hz / 80 Hz / 120 Hz / THROU

"PHASE : Adjust the phase for Non-Fading output.

Setting values: NOR (0°) / REV (180°)

Storing your settings of the Crossover network:

Press a preset button (#1-6) for at least two seconds.

Recalling your settings of the Crossover network:

Press a preset button (#1-6) for the desired Crossover network setting.

— 15 —