Audio Control Setting

Adjust various parameters of sound quality.

1Press the AUD button repeatedly and switch the display to “AUDIO CTRL” to enter the audio control mode.

Pressing the button cycles through Audio control mode, Crossover control mode, and Control mode off.

2Selecting mode

Press either the FM or AM button.

Each time the button is pressed, the adjustment mode will change.

Please refer to the following for the contents of the adjustment modes.

NOTE Source tone memory

Each source ( CD, FM, AM and disc changer ) has its own memory in which to store the KEX.P, bass center frequency, bass level, bass quality factor, bass extension, treble center frequency, and treble level settings.

The settings made for a particular source are recalled automatically whenever you use that source ( for example, FM mode uses the tone settings made for FM, AM for AM, etc.).

3Adjust each mode

Press the 4/¢ button.

Please refer to the following for the adjusting values.

4Press the AUD button twice to end the audio control mode.

"KEX.P." : Recalling the kenwood preset sound setting Press the preset buttons (#1-6).

Setting values: #1;Flat, #2;Rock, #3;Top40, #4;Jazz, #5;Easy, #6;Scan of #1-5

NOTE

•This mode is available only when the Sound coordinate system is on. (page 35)

•You can call the following settings with this function; bass center frequency, bass level, bass quality factor, bass extension, treble center frequency, and treble level setting.

"BASS f" : Adjust the center frequency of the bass.

Setting values: 60 / 70 / 80 / 100 (Only when the bass quality factor is set to 1.00, 1.25 or 1.50) / 150 (Only when the bass quality factor is set to 2.00) Hz

NOTE

This mode is available only when the Sound coordinate system is on. (page 35)

"BASS" : Adjust the bass level.

Setting values: - 6 – + 6

"BASS Q" : Adjust the Bass quality factor. Setting values: 1.00 / 1.25 / 1.50 / 2.00

NOTE

This mode is available only when the Sound coordinate system is on. (page 35)

— 13 —