Kingston Technology MC133PD manual Installing the MCMaster

Hardware Installation 7

Installing the MCMaster

1.Make sure that the system power switch is OFF.

2.Unlock and remove the system cover. Your PS/2 Quick Reference provides detailed instructions for removing or reinstalling the cover.

3.Choose a vacant expansion slot to plug MCMaster card into. MCMaster will work in a 16 or 32-bit slot. If you're installing it in a 32-bit system, such as a Model 70 or 80, you'll want to install it in a 32-bit slot to take full advantage of the 80486 processor's 32-bit bus width.

4.Loosen the screw that holds the expansion slot cover, and slide out the expansion slot cover. Save it.

5.Install MCMaster board in its slot by carefully sliding it in until the board snaps into place. Be careful that the forked bottom of the backplate goes outside the lip of the chassis. Finger-tighten the screw.

6.Replace the system cover, and tighten the screws.

MCMaster User’s Guide - Rev. B06 Kingston Technology Company