30 | Appendix C Troubleshooting |
Attributes are SELECTED and LOOPING. Once you have positioned the highlight bar over the test you wish to select or loop on
The attribute may be changed using the following Keys: L - Toggles Looping on and off.
S - Toggles Selection on and off.
Note that the Looping attribute overrides the selected attribute
And that activating Looping implies selected To STOP TESTING - press any key.
To QUIT THE PROGRAM - press ESC or "Q".
7.MMDIAG will automatically load the appropriate tests for the version of the MCMaster you have installed.
8.When prompted, press any key to continue. At this point, the main diagnostic screen will appear:
MCMaster 486 Diagnostics. Ver. x.xx
(C)1993 Kingston.
Test | Active | Sel | Loop | Pass | Fail |
Test Board ID |
| Sel |
| UNTESTED | UNTESTED |
Test POS data lines |
| Sel |
| UNTESTED | UNTESTED |
Test SRAM data lines. |
| Sel |
| UNTESTED | UNTESTED |
Test SRAM address quick. Sel |
| UNTESTED | UNTESTED |
| |
Running in a Model 60. Setting max slots to 08 Microchannel is Implemented. MCMaster Environment: Hardware Rev = 000000
Code Rev = 01.00
IO base address = 0390
Notice that the display is divided into three windows. At the top is the Kingston copyright notice and revision level of MMDIAG. The middle window contains a portion of the list of tests to be performed. This test list is scrollable. The green highlight bar (shown here as an underscored line) is used in conjunction with other keys to select tests. The up and down arrow keys move it. If the test list is longer than four tests, the list will scroll up and down in the window as required. The bottom window is the status window. As the diagnostic runs,
Kingston Technology Company | MCMaster User’s Guide - Rev. B06 |
