8-3

ADJUSTING THE ICE THICKNESS
Electrical Shock Hazard
Disconnect power before servicing.
Replace all parts and panels before
operating.
Failure to do so can result in death or
electrical shock.
WARNING
Control board #6100499 with Code Date MGR/
0245 (45th week, 2002), or higher, will allow ice
thickness adjustments. The approximate ice
thickness settings are as follows:
Ice Thickness @ Normal = 0.32″ (8.1 mm)
Ice Thickness @ Thin = 0.28″ (7.0 mm)
Ice Thickness @ Thick = 0.39″ (9.9 mm)
Ice Thickness Jumper
2
3
5
41
2

Normal Thick Thin

Jumper At P4 Shown In The
Factory Default (Normal) Position
1
25
4
34
Ice thickness is controlled by the placement of
a jumper at P4 on the control board. The
jumper positions for the three ice thickness
settings are shown below. NOTE: If the jumper
is missing, or in any position other than those
shown below, the unit will produce normal ice
thickness.