4-3
8. To remove the evaporator thermistor:
a) Remove the cutter grid from the unit
(see step 7 on page 4-2 for the proce-
dure).
b) Disconnect the evaporator thermistor
connector from the bottom of the con-
trol housing.
c) Remove the two hex-head mounting
screws from the water trough and pull
the trough from the unit.
c) Slide the cutter grid forward and out of
the unit and place it on a work surface.
Be careful not to scratch the ice maker
liner.
d) Remove the spacer from the right cut-
ter grid bracket tab.
e) Lift the two ice guides from the cutter
grid tabs. Note the orientation of the
guides with the straight side facing in.
There should be a slight outward tilt
after the guides are installed. Bend the
metal tabs outward, if necessary.
Position Ice Guide
With Straight Side
As Shown
Cutter Grid
Ice Guides
SpacerSlide Out Cutter Grid
d) Reach behind the accumulator, and
unclip the evaporator thermistor from
the evaporator tubing and remove it.
Evap Thermistor Connector
Control Housing
Water Trough Screws
Water Trough
Continued on the next page.
Accumulator
Evaporator Thermistor
Bottom Of The Evaporator