4.Gently slide the grill completely into the outdoor enclosure.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death, fire, or electrical shock.
5.Plug
■To avoid electrical shock, do not immerse cord or plugs in water or other liquid.
■Unplug from the outlet when not in use and before cleaning. Allow to cool before putting on or taking off parts.
■Do not operate any outdoor cooking gas appliance with a damaged cord, damaged plug, or after the appliance malfunctions or has been damaged in any manner. Contact the manufacturer for repair.
■Do not let the cord hang over the edge of a table or touch hot surfaces.
■Do not use an outdoor cooking appliance for purposes other than intended.
■When connecting, first connect plug to the outdoor cooking gas appliance then plug appliance into the outlet.
■Use only a Ground Fault Interrupter (GFI) protected circuit with this outdoor cooking gas appliance.
■Do not remove the ground prong or use with an adapter of 2 prongs.
6.Go to the “Check and Adjust the Burners” section.
GAS CONVERSIONS
For Models Equipped for Use with a 20 lb LP gas Tank
NOTE: Models that are equipped for Natural gas require Gas Conversion Kit Part Number W10118099 for conversion to LP gas. Use the conversion instructions included in the kit. See “Assistance or Service” section for information on ordering.
Tools and Parts for Gas Conversion
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Tools needed
■ | Phillips screwdriver | ■ | 10 mm wrench |
■ | Pipe wrench | ■ | Thin |
■ | Adjustable wrench | ■ | Pliers |
■ 6 mm socket and wrench | ■ | Pipe thread sealant | |
| or 6 mm nut driver |
| certified for LP gas |
Parts supplied
■Brass connector
■Convertible regulator 4" W.C. Natural, 11" W.C. LP
■Natural gas orifices
IMPORTANT: Gas conversions must be done by a qualified installer. Before proceeding with conversion, shut off the gas supply to the appliance prior to disconnecting the electrical power.
This kit is designed for use from sea level up to 2000 ft elevation. For higher elevations contact KitchenAid at
WARNING
Explosion Hazard
Use a new CSA International approved “outdoor” gas supply line.
Securely tighten all gas connections.
If connected to LP, have a qualified person make sure gas pressure does not exceed 11” (28 cm) water column.
Examples of a qualified person include:
licensed heating personnel,
authorized gas company personnel, and authorized service personnel.
Failure to do so can result in death, explosion, or fire.
18
