Knoll Systems HDP6000 user manual ? No start up screen? Get help on, Remove the top front lid

11

Computer connections

You can connect a computer‟s VGA connector to the VGA input on the projector using a VGA cable.

RS-232 connections

You can control the projector from an LCD control panel or computer by connecting an RS-232 cable to the projector‟s Serial control connector.

Displaying an image

Connect the power cord to the Power connector cord	plug in power
on the back of the projector and to your electrical outlet.
NOTE: Always use the power cord that shipped with the projector.
Press the Power button on the remote control.
The LED blinks green and the fans start to run.	press power button
When the lamp comes on, the start-up screen is displayed
and the LED is steady green. It can take a minute for the
image to achieve full brightness.
? No start up screen? Get help on page 13
Plug in, connect, and turn on your video device.
The video device‟s image should appear on the	turn on video device
projection screen. If it doesn‟t, press the Source button
on the remote until the image appears.
If you are using a laptop the VGA output may have to
Be enabled to view an image.
Adjusting the image
Adjust the image by tilting the projector up or down	adjust height

Position the projector the desired distance from the screen at a 90-degree angle to the screen.

See page 8 for a table listing screen sizes and distances to the screen.

Remove the top front lid.

a.Slide the tabs on the side toward the rear of the projector to unlock the projector top cover.

b.Slide the top toward the front of the projector to unhook it from the projector body.

c.Lift off.