Kodak 5500 manual Fax Connections, DSL Line, PBX or ISDN Line

Models: 5500

1 120
Download 120 pages 51.95 Kb
Page 28
Image 28
Fax Connections

Chapter 2

1Press Menu to display the Main Menu.

2Press b until Reset All Settings is selected.

3Press OK.

Fax Connections

After completing all steps in the Setup Poster, use the instructions in this section to connect the fax feature of your Kodak EasyShare AiO.

DSL Line

If you have Digital Subscriber Line (DSL) service through your phone company, use the instructions in this section to connect a DSL filter between the telephone wall jack and your Kodak EasyShare AiO. This filter removes the digital signal that would block your EasyShare AiO from communicating properly with the telephone line.

CAUTION

If you have a DSL line and do not connect the DSL filter, you will not be able to send and receive faxes with your EasyShare AiO.

1Obtain a DSL filter from your DSL provider.

2Connect the phone cord supplied with your Kodak EasyShare AiO to the open port on the DSL filter and the port labeled 1-LINE.

3Connect the DSL filter cord to the telephone wall jack.

PBX or ISDN Line

If your telephone line has a PBX system, make sure you dial the number for an outside line before dialing the fax number.

CAUTION

Many digital PBX systems include a call-waiting tone that is factory-set to On. This call-waiting tone will interfere with any fax transmission, and you will not be able to send or receive faxes with your Kodak EasyShare AiO. You can disable call-waiting from the AiO Home Center.

If you are using either a PBX or an ISDN converter, make sure the EasyShare AiO is connected to the port that is designated for fax and phone use.

Some ISDN systems allow you to configure the ports for specific phone equipment—for example, you might have assigned one for telephone and Group 3 fax and another for multiple purposes.

24

Kodak EasyShare 5500 AiO

Page 28
Image 28
Kodak 5500 manual Fax Connections, DSL Line, PBX or ISDN Line