Kodak DryView 8900 manual Release the two clamps at the left of the processor, Open the drum cover

Troubleshooting

3. Release the two clamps at the left of the processor.

CAUTION:

Whenever you raise or lower the drum cover, grasp the cover only on the lift handle to avoid the possibility of pinching your fingers.

4. Open the drum cover.

CAUTION:

To prevent damage to the surface of the processor drum, do not use any type of tool to remove jammed film.

5.Clear the jammed film from the processor area. There may be more than one sheet.

NOTE: If the film is jammed in the lower section of Area 4, open the front door to remove the film (see “Clearing Film Jams from Area 2” on page 4-27).

6.Close the drum cover and secure it with the two clamps.

7.Close the hood.

8.If you cannot clear the jammed film, call an Authorized Service Provider of Kodak products.

NOTE: The processor has to warm up to operating temperature before the processor can print.

4-30 5E6155 January 10, 2006